- int udma_ok = 1, mode = 0;
- ide_hwif_t *hwif = HWIF(drive);
- int unit = drive->select.b.unit;
- ide_drive_t *mate = &hwif->drives[unit^1];
- struct hd_driveid *id = drive->id;
-
- /*
- * The SC1200 specifies that two drives sharing a cable cannot
- * mix UDMA/MDMA. It has to be one or the other, for the pair,
- * though different timings can still be chosen for each drive.
- * We could set the appropriate timing bits on the fly,
- * but that might be a bit confusing. So, for now we statically
- * handle this requirement by looking at our mate drive to see
- * what it is capable of, before choosing a mode for our own drive.
- */
- if (mate->present) {
- struct hd_driveid *mateid = mate->id;
- if (mateid && (mateid->capability & 1) && !__ide_dma_bad_drive(mate)) {
- if ((mateid->field_valid & 4) && (mateid->dma_ultra & 7))
- udma_ok = 1;
- else if ((mateid->field_valid & 2) && (mateid->dma_mword & 7))
- udma_ok = 0;
- else
- udma_ok = 1;
- }
- }
- /*
- * Now see what the current drive is capable of,
- * selecting UDMA only if the mate said it was ok.
- */
- if (id && (id->capability & 1) && hwif->autodma && !__ide_dma_bad_drive(drive)) {
- if (udma_ok && (id->field_valid & 4) && (id->dma_ultra & 7)) {
- if (id->dma_ultra & 4)
- mode = XFER_UDMA_2;
- else if (id->dma_ultra & 2)
- mode = XFER_UDMA_1;
- else if (id->dma_ultra & 1)
- mode = XFER_UDMA_0;
- }
- if (!mode && (id->field_valid & 2) && (id->dma_mword & 7)) {
- if (id->dma_mword & 4)
- mode = XFER_MW_DMA_2;
- else if (id->dma_mword & 2)
- mode = XFER_MW_DMA_1;
- else if (id->dma_mword & 1)
- mode = XFER_MW_DMA_0;
- }
- }
- return mode;
+ ide_hwif_t *hwif = drive->hwif;
+ struct pci_dev *pdev = hwif->pci_dev;
+ unsigned int basereg = hwif->channel ? 0x50 : 0x40, format = 0;
+
+ pci_read_config_dword(pdev, basereg + 4, &format);
+ format = (format >> 31) & 1;
+ if (format)
+ format += sc1200_get_pci_clock();
+ pci_write_config_dword(pdev, basereg + ((drive->dn & 1) << 3),
+ sc1200_pio_timings[format][pio]);