hwmon: Add LM93 support

[linux-2.6-omap-h63xx.git] / Documentation / hwmon / sysfs-interface

diff --git a/Documentation/hwmon/sysfs-interface b/Documentation/hwmon/sysfs-interface
index efef3b962cd3eb86f586e811b77ad7b6eadee648..b3a9e1b9dbda9458b5d4215f50b3b217284c3b82 100644 (file)
--- a/Documentation/hwmon/sysfs-interface
+++ b/Documentation/hwmon/sysfs-interface
@@ -152,6 +152,13 @@ fan[1-*]_div       Fan divisor.
                Note that this is actually an internal clock divisor, which
                affects the measurable speed range, not the read value.
 
+fan[1-*]_target
+               Desired fan speed
+               Unit: revolution/min (RPM)
+               RW
+               Only makes sense if the chip supports closed-loop fan speed
+               control based on the measured fan speed.
+
 Also see the Alarms section for status flags associated with fans.
 
 
@@ -165,17 +172,21 @@ pwm[1-*]  Pulse width modulation fan control.
                255 is max or 100%.
 
 pwm[1-*]_enable
-               Switch PWM on and off.
-               Not always present even if fan*_pwm is.
-               0: turn off
-               1: turn on in manual mode
-               2+: turn on in automatic mode
-               Check individual chip documentation files for automatic mode details.
+               Fan speed control method:
+               0: no fan speed control (i.e. fan at full speed)
+               1: manual fan speed control enabled (using pwm[1-*])
+               2+: automatic fan speed control enabled
+               Check individual chip documentation files for automatic mode
+               details.
+               RW
+
+pwm[1-*]_mode  0: DC mode (direct current)
+               1: PWM mode (pulse-width modulation)
                RW
 
-pwm[1-*]_mode
-               0: DC mode
-               1: PWM mode
+pwm[1-*]_freq  Base PWM frequency in Hz.
+               Only possibly available when pwmN_mode is PWM, but not always
+               present even then.
                RW
 
 pwm[1-*]_auto_channels_temp
@@ -331,9 +342,9 @@ to notify open diodes, unconnected fans etc. where the hardware
 supports it. When this boolean has value 1, the measurement for that
 channel should not be trusted.
 
-in[0-*]_input_fault
-fan[1-*]_input_fault
-temp[1-*]_input_fault
+in[0-*]_fault
+fan[1-*]_fault
+temp[1-*]_fault
                Input fault condition
                0: no fault occured
                1: fault condition