Note that this is actually an internal clock divisor, which
affects the measurable speed range, not the read value.
+fan[1-*]_target
+ Desired fan speed
+ Unit: revolution/min (RPM)
+ RW
+ Only makes sense if the chip supports closed-loop fan speed
+ control based on the measured fan speed.
+
Also see the Alarms section for status flags associated with fans.
255 is max or 100%.
pwm[1-*]_enable
- Switch PWM on and off.
- Not always present even if pwmN is.
- 0: turn off
- 1: turn on in manual mode
- 2+: turn on in automatic mode
+ Fan speed control method:
+ 0: no fan speed control (i.e. fan at full speed)
+ 1: manual fan speed control enabled (using pwm[1-*])
+ 2+: automatic fan speed control enabled
Check individual chip documentation files for automatic mode
details.
RW
supports it. When this boolean has value 1, the measurement for that
channel should not be trusted.
-in[0-*]_input_fault
-fan[1-*]_input_fault
-temp[1-*]_input_fault
+in[0-*]_fault
+fan[1-*]_fault
+temp[1-*]_fault
Input fault condition
0: no fault occured
1: fault condition