acpi_irq_isa= [HW,ACPI] If irq_balance, mark listed IRQs used by ISA
Format: <irq>,<irq>...
+ acpi_new_pts_ordering [HW,ACPI]
+ Enforce the ACPI 2.0 ordering of the _PTS control
+ method wrt putting devices into low power states
+ default: pre ACPI 2.0 ordering of _PTS
+
acpi_no_auto_ssdt [HW,ACPI] Disable automatic loading of SSDT
acpi_os_name= [HW,ACPI] Tell ACPI BIOS the name of the OS
1 will print _a lot_ more information - normally
only useful to kernel developers.
- decnet= [HW,NET]
+ decnet.addr= [HW,NET]
Format: <area>[,<node>]
See also Documentation/networking/decnet.txt.
See Documentation/isdn/README.HiSax.
hugepages= [HW,X86-32,IA-64] Maximal number of HugeTLB pages.
+ hugepagesz= [HW,IA-64,PPC] The size of the HugeTLB pages.
i8042.direct [HW] Put keyboard port into non-translated mode
i8042.dumbkbd [HW] Pretend that controller can only read data from
ramdisk_size= [RAM] Sizes of RAM disks in kilobytes
See Documentation/ramdisk.txt.
- rcu.blimit= [KNL,BOOT] Set maximum number of finished
- RCU callbacks to process in one batch.
+ rcupdate.blimit= [KNL,BOOT]
+ Set maximum number of finished RCU callbacks to process
+ in one batch.
- rcu.qhimark= [KNL,BOOT] Set threshold of queued
+ rcupdate.qhimark= [KNL,BOOT]
+ Set threshold of queued
RCU callbacks over which batch limiting is disabled.
- rcu.qlowmark= [KNL,BOOT] Set threshold of queued
- RCU callbacks below which batch limiting is re-enabled.
+ rcupdate.qlowmark= [KNL,BOOT]
+ Set threshold of queued RCU callbacks below which
+ batch limiting is re-enabled.
rdinit= [KNL]
Format: <full_path>
st= [HW,SCSI] SCSI tape parameters (buffers, etc.)
See Documentation/scsi/st.txt.
- st0x= [HW,SCSI]
- See header of drivers/scsi/seagate.c.
-
sti= [PARISC,HW]
Format: <num>
Set the STI (builtin display/keyboard on the HP-PARISC
tipar.delay= [HW,PPT]
Set inter-bit delay in microseconds (default 10).
- tmc8xx= [HW,SCSI]
- See header of drivers/scsi/seagate.c.
-
tmscsim= [HW,SCSI]
See comment before function dc390_setup() in
drivers/scsi/tmscsim.c.