.pins[1] = 3,
};
-static struct omap_mmc_config h3_mmc_config __initdata = {
- .mmc[0] = {
- .enabled = 1,
- .wire4 = 1,
- },
-};
-
-extern struct omap_mmc_platform_data h3_mmc_data;
-
static struct omap_uart_config h3_uart_config __initdata = {
.enabled_uarts = ((1 << 0) | (1 << 1) | (1 << 2)),
};
static struct omap_board_config_kernel h3_config[] __initdata = {
{ OMAP_TAG_USB, &h3_usb_config },
- { OMAP_TAG_MMC, &h3_mmc_config },
{ OMAP_TAG_UART, &h3_uart_config },
{ OMAP_TAG_LCD, &h3_lcd_config },
};
static int nand_dev_ready(struct omap_nand_platform_data *data)
{
- return omap_get_gpio_datain(H3_NAND_RB_GPIO_PIN);
+ return gpio_get_value(H3_NAND_RB_GPIO_PIN);
}
static void __init h3_init(void)
nand_resource.end = nand_resource.start = OMAP_CS2B_PHYS;
nand_resource.end += SZ_4K - 1;
- if (!(omap_request_gpio(H3_NAND_RB_GPIO_PIN)))
- nand_data.dev_ready = nand_dev_ready;
+ if (gpio_request(H3_NAND_RB_GPIO_PIN, "NAND ready") < 0)
+ BUG();
+ nand_data.dev_ready = nand_dev_ready;
/* GPIO10 Func_MUX_CTRL reg bit 29:27, Configure V2 to mode1 as GPIO */
/* GPIO10 pullup/down register, Enable pullup on GPIO10 */
static void __init h3_init_smc91x(void)
{
omap_cfg_reg(W15_1710_GPIO40);
- if (omap_request_gpio(40) < 0) {
+ if (gpio_request(40, "SMC91x irq") < 0) {
printk("Error requesting gpio 40 for smc91x irq\n");
return;
}