#include <linux/init.h>
#include <linux/platform_device.h>
#include <linux/irq.h>
+#include <linux/interrupt.h>
#include <linux/mtd/mtd.h>
#include <linux/mtd/partitions.h>
* can't talk to the ads or even the i2c eeprom.
*/
+ /* parallel camera interface */
+ omap_cfg_reg(J15_1610_CAM_LCLK);
+ omap_cfg_reg(J18_1610_CAM_D7);
+ omap_cfg_reg(J19_1610_CAM_D6);
+ omap_cfg_reg(J14_1610_CAM_D5);
+ omap_cfg_reg(K18_1610_CAM_D4);
+ omap_cfg_reg(K19_1610_CAM_D3);
+ omap_cfg_reg(K15_1610_CAM_D2);
+ omap_cfg_reg(K14_1610_CAM_D1);
+ omap_cfg_reg(L19_1610_CAM_D0);
+ omap_cfg_reg(L18_1610_CAM_VS);
+ omap_cfg_reg(L15_1610_CAM_HS);
+ omap_cfg_reg(M19_1610_CAM_RSTZ);
+ omap_cfg_reg(Y15_1610_CAM_OUTCLK);
+
+ /* serial camera interface */
+ omap_cfg_reg(H19_1610_CAM_EXCLK);
+ omap_cfg_reg(W13_1610_CCP_CLKM);
+ omap_cfg_reg(Y12_1610_CCP_CLKP);
+ /* CCP_DATAM CONFLICTS WITH UART1.TX (and serial console) */
+ // omap_cfg_reg(Y14_1610_CCP_DATAM);
+ omap_cfg_reg(W14_1610_CCP_DATAP);
+
+ /* CAM_PWDN */
+ if (omap_request_gpio(11) == 0) {
+ omap_cfg_reg(N20_1610_GPIO11);
+ omap_set_gpio_direction(11, 0 /* out */);
+ omap_set_gpio_dataout(11, 0 /* off */);
+ } else
+ pr_debug("OSK+Mistral: CAM_PWDN is awol\n");
+
+
// omap_cfg_reg(P19_1610_GPIO6); // BUSY
omap_cfg_reg(P20_1610_GPIO4); // PENIRQ
set_irq_type(OMAP_GPIO_IRQ(4), IRQT_FALLING);
/* Workaround for wrong CS3 (NOR flash) timing
* There are some U-Boot versions out there which configure
* wrong CS3 memory timings. This mainly leads to CRC
- * or similiar errors if you use NOR flash (e.g. with JFFS2)
+ * or similar errors if you use NOR flash (e.g. with JFFS2)
*/
if (EMIFS_CCS(3) != EMIFS_CS3_VAL)
EMIFS_CCS(3) = EMIFS_CS3_VAL;