#include <linux/workqueue.h>
#include <linux/err.h>
#include <linux/clk.h>
-#include <linux/i2c/twl4030.h>
#include <linux/spi/spi.h>
#include <linux/spi/ads7846.h>
+#include <linux/i2c/twl4030.h>
-#include <asm/hardware.h>
+#include <mach/hardware.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <asm/mach/map.h>
-#include <asm/arch/mcspi.h>
-#include <asm/arch/gpio.h>
-#include <asm/arch/mux.h>
-#include <asm/arch/board.h>
-#include <asm/arch/usb-musb.h>
-#include <asm/arch/usb-ehci.h>
-#include <asm/arch/hsmmc.h>
-#include <asm/arch/common.h>
-#include <asm/arch/keypad.h>
-#include <asm/arch/dma.h>
-#include <asm/arch/gpmc.h>
+#include <mach/mcspi.h>
+#include <mach/gpio.h>
+#include <mach/mux.h>
+#include <mach/board.h>
+#include <mach/usb-musb.h>
+#include <mach/usb-ehci.h>
+#include <mach/hsmmc.h>
+#include <mach/common.h>
+#include <mach/keypad.h>
+#include <mach/dma.h>
+#include <mach/gpmc.h>
#include <asm/io.h>
#include <asm/delay.h>
+#include <mach/control.h>
+
+#include "sdram-qimonda-hyb18m512160af-6.h"
#define SDP3430_SMC91X_CS 3
#define ENABLE_VAUX3_DEV_GRP 0x20
+#define TWL4030_MSECURE_GPIO 22
+
static struct resource sdp3430_smc91x_resources[] = {
[0] = {
.start = OMAP34XX_ETHR_START,
0
};
-static struct omap_kp_platform_data sdp3430_kp_data = {
+static struct twl4030_keypad_data sdp3430_kp_data = {
.rows = 5,
.cols = 6,
- .keymap = sdp3430_keymap,
- .keymapsize = ARRAY_SIZE(sdp3430_keymap),
+ .keymap = sdp3430_keymap,
+ .keymapsize = ARRAY_SIZE(sdp3430_keymap),
.rep = 1,
-};
-
-static struct platform_device sdp3430_kp_device = {
- .name = "omap_twl4030keypad",
- .id = -1,
- .dev = {
- .platform_data = &sdp3430_kp_data,
- },
+ .irq = TWL4030_MODIRQ_KEYPAD,
};
static int ts_gpio;
+static int __init msecure_init(void)
+{
+ int ret = 0;
+
+#ifdef CONFIG_RTC_DRV_TWL4030
+ /* 3430ES2.0 doesn't have msecure/gpio-22 line connected to T2 */
+ if (omap_type() == OMAP2_DEVICE_TYPE_GP &&
+ system_rev < OMAP3430_REV_ES2_0) {
+ u32 msecure_pad_config_reg = omap_ctrl_base_get() + 0xA3C;
+ int mux_mask = 0x04;
+ u16 tmp;
+
+ ret = gpio_request(TWL4030_MSECURE_GPIO, "msecure");
+ if (ret < 0) {
+ printk(KERN_ERR "msecure_init: can't"
+ "reserve GPIO:%d !\n", TWL4030_MSECURE_GPIO);
+ goto out;
+ }
+ /*
+ * TWL4030 will be in secure mode if msecure line from OMAP
+ * is low. Make msecure line high in order to change the
+ * TWL4030 RTC time and calender registers.
+ */
+ tmp = omap_readw(msecure_pad_config_reg);
+ tmp &= 0xF8; /* To enable mux mode 03/04 = GPIO_RTC */
+ tmp |= mux_mask;/* To enable mux mode 03/04 = GPIO_RTC */
+ omap_writew(tmp, msecure_pad_config_reg);
+
+ gpio_direction_output(TWL4030_MSECURE_GPIO, 1);
+ }
+out:
+#endif
+ return ret;
+}
+
/**
* @brief ads7846_dev_init : Requests & sets GPIO line for pen-irq
*
static struct platform_device *sdp3430_devices[] __initdata = {
&sdp3430_smc91x_device,
- &sdp3430_kp_device,
&sdp3430_lcd_device,
};
sdp3430_smc91x_resources[0].end = cs_mem_base + 0xf;
udelay(100);
- if (is_sil_rev_greater_than(OMAP3430_REV_ES1_0))
+ if (system_rev > OMAP3430_REV_ES1_0)
eth_gpio = OMAP34XX_ETHR_GPIO_IRQ_SDPV2;
else
eth_gpio = OMAP34XX_ETHR_GPIO_IRQ_SDPV1;
static void __init omap_3430sdp_init_irq(void)
{
- omap2_init_common_hw();
+ omap2_init_common_hw(hyb18m512160af6_sdrc_params);
omap_init_irq();
omap_gpio_init();
sdp3430_init_smc91x();
.ctrl_name = "internal",
};
-static struct omap_mmc_config sdp3430_mmc_config __initdata = {
- .mmc [0] = {
- .enabled = 1,
- .wire4 = 1,
- },
-};
-
static struct omap_board_config_kernel sdp3430_config[] __initdata = {
{ OMAP_TAG_UART, &sdp3430_uart_config },
- {OMAP_TAG_LCD, &sdp3430_lcd_config},
- {OMAP_TAG_MMC, &sdp3430_mmc_config },
+ { OMAP_TAG_LCD, &sdp3430_lcd_config },
+};
+
+static int sdp3430_batt_table[] = {
+/* 0 C*/
+30800, 29500, 28300, 27100,
+26000, 24900, 23900, 22900, 22000, 21100, 20300, 19400, 18700, 17900,
+17200, 16500, 15900, 15300, 14700, 14100, 13600, 13100, 12600, 12100,
+11600, 11200, 10800, 10400, 10000, 9630, 9280, 8950, 8620, 8310,
+8020, 7730, 7460, 7200, 6950, 6710, 6470, 6250, 6040, 5830,
+5640, 5450, 5260, 5090, 4920, 4760, 4600, 4450, 4310, 4170,
+4040, 3910, 3790, 3670, 3550
+};
+
+static struct twl4030_bci_platform_data sdp3430_bci_data = {
+ .battery_tmp_tbl = sdp3430_batt_table,
+ .tblsize = ARRAY_SIZE(sdp3430_batt_table),
+};
+
+static struct twl4030_gpio_platform_data sdp3430_gpio_data = {
+ .gpio_base = OMAP_MAX_GPIO_LINES,
+ .irq_base = TWL4030_GPIO_IRQ_BASE,
+ .irq_end = TWL4030_GPIO_IRQ_END,
+};
+
+static struct twl4030_usb_data sdp3430_usb_data = {
+ .usb_mode = T2_USB_MODE_ULPI,
+};
+
+static struct twl4030_madc_platform_data sdp3430_madc_data = {
+ .irq_line = 1,
+};
+
+static struct twl4030_platform_data sdp3430_twldata = {
+ .irq_base = TWL4030_IRQ_BASE,
+ .irq_end = TWL4030_IRQ_END,
+
+ /* platform_data for children goes here */
+ .bci = &sdp3430_bci_data,
+ .gpio = &sdp3430_gpio_data,
+ .madc = &sdp3430_madc_data,
+ .keypad = &sdp3430_kp_data,
+ .usb = &sdp3430_usb_data,
+};
+
+static struct i2c_board_info __initdata sdp3430_i2c_boardinfo[] = {
+ {
+ I2C_BOARD_INFO("twl4030", 0x48),
+ .flags = I2C_CLIENT_WAKE,
+ .irq = INT_34XX_SYS_NIRQ,
+ .platform_data = &sdp3430_twldata,
+ },
};
static int __init omap3430_i2c_init(void)
{
- omap_register_i2c_bus(1, 2600, NULL, 0);
+ omap_register_i2c_bus(1, 2600, sdp3430_i2c_boardinfo,
+ ARRAY_SIZE(sdp3430_i2c_boardinfo));
omap_register_i2c_bus(2, 400, NULL, 0);
omap_register_i2c_bus(3, 400, NULL, 0);
return 0;
static void __init omap_3430sdp_init(void)
{
+ omap3430_i2c_init();
platform_add_devices(sdp3430_devices, ARRAY_SIZE(sdp3430_devices));
omap_board_config = sdp3430_config;
omap_board_config_size = ARRAY_SIZE(sdp3430_config);
- if (is_sil_rev_greater_than(OMAP3430_REV_ES1_0))
+ if (system_rev > OMAP3430_REV_ES1_0)
ts_gpio = OMAP34XX_TS_GPIO_IRQ_SDPV2;
else
ts_gpio = OMAP34XX_TS_GPIO_IRQ_SDPV1;
ARRAY_SIZE(sdp3430_spi_board_info));
ads7846_dev_init();
sdp3430_flash_init();
+ msecure_init();
omap_serial_init();
usb_musb_init();
usb_ehci_init();
omap2_set_globals_343x();
omap2_map_common_io();
}
-arch_initcall(omap3430_i2c_init);
MACHINE_START(OMAP_3430SDP, "OMAP3430 3430SDP board")
/* Maintainer: Syed Khasim - Texas Instruments Inc */