#include <plat/irq.h>
#include "common.h"
-/*****************************************************************************
- * Orion GPIO IRQ
- *
- * GPIO_IN_POL register controlls whether GPIO_DATA_IN will hold the same
- * value of the line or the opposite value.
- *
- * Level IRQ handlers: DATA_IN is used directly as cause register.
- * Interrupt are masked by LEVEL_MASK registers.
- * Edge IRQ handlers: Change in DATA_IN are latched in EDGE_CAUSE.
- * Interrupt are masked by EDGE_MASK registers.
- * Both-edge handlers: Similar to regular Edge handlers, but also swaps
- * the polarity to catch the next line transaction.
- * This is a race condition that might not perfectly
- * work on some use cases.
- *
- * Every eight GPIO lines are grouped (OR'ed) before going up to main
- * cause register.
- *
- * EDGE cause mask
- * data-in /--------| |-----| |----\
- * -----| |----- ---- to main cause reg
- * X \----------------| |----/
- * polarity LEVEL mask
- *
- ****************************************************************************/
-static void orion5x_gpio_irq_ack(u32 irq)
-{
- int pin = irq_to_gpio(irq);
- if (irq_desc[irq].status & IRQ_LEVEL)
- /*
- * Mask bit for level interrupt
- */
- orion5x_clrbits(GPIO_LEVEL_MASK, 1 << pin);
- else
- /*
- * Clear casue bit for egde interrupt
- */
- orion5x_clrbits(GPIO_EDGE_CAUSE, 1 << pin);
-}
-
-static void orion5x_gpio_irq_mask(u32 irq)
-{
- int pin = irq_to_gpio(irq);
- if (irq_desc[irq].status & IRQ_LEVEL)
- orion5x_clrbits(GPIO_LEVEL_MASK, 1 << pin);
- else
- orion5x_clrbits(GPIO_EDGE_MASK, 1 << pin);
-}
-
-static void orion5x_gpio_irq_unmask(u32 irq)
+static void gpio_irq_handler(unsigned int irq, struct irq_desc *desc)
{
- int pin = irq_to_gpio(irq);
- if (irq_desc[irq].status & IRQ_LEVEL)
- orion5x_setbits(GPIO_LEVEL_MASK, 1 << pin);
- else
- orion5x_setbits(GPIO_EDGE_MASK, 1 << pin);
-}
-
-static int orion5x_gpio_set_irq_type(u32 irq, u32 type)
-{
- int pin = irq_to_gpio(irq);
- struct irq_desc *desc;
-
- if ((readl(GPIO_IO_CONF) & (1 << pin)) == 0) {
- printk(KERN_ERR "orion5x_gpio_set_irq_type failed "
- "(irq %d, pin %d).\n", irq, pin);
- return -EINVAL;
- }
-
- desc = irq_desc + irq;
-
- switch (type) {
- case IRQ_TYPE_LEVEL_HIGH:
- desc->handle_irq = handle_level_irq;
- desc->status |= IRQ_LEVEL;
- orion5x_clrbits(GPIO_IN_POL, (1 << pin));
- break;
- case IRQ_TYPE_LEVEL_LOW:
- desc->handle_irq = handle_level_irq;
- desc->status |= IRQ_LEVEL;
- orion5x_setbits(GPIO_IN_POL, (1 << pin));
- break;
- case IRQ_TYPE_EDGE_RISING:
- desc->handle_irq = handle_edge_irq;
- desc->status &= ~IRQ_LEVEL;
- orion5x_clrbits(GPIO_IN_POL, (1 << pin));
- break;
- case IRQ_TYPE_EDGE_FALLING:
- desc->handle_irq = handle_edge_irq;
- desc->status &= ~IRQ_LEVEL;
- orion5x_setbits(GPIO_IN_POL, (1 << pin));
- break;
- case IRQ_TYPE_EDGE_BOTH:
- desc->handle_irq = handle_edge_irq;
- desc->status &= ~IRQ_LEVEL;
- /*
- * set initial polarity based on current input level
- */
- if ((readl(GPIO_IN_POL) ^ readl(GPIO_DATA_IN))
- & (1 << pin))
- orion5x_setbits(GPIO_IN_POL, (1 << pin)); /* falling */
- else
- orion5x_clrbits(GPIO_IN_POL, (1 << pin)); /* rising */
-
- break;
- default:
- printk(KERN_ERR "failed to set irq=%d (type=%d)\n", irq, type);
- return -EINVAL;
- }
-
- desc->status &= ~IRQ_TYPE_SENSE_MASK;
- desc->status |= type & IRQ_TYPE_SENSE_MASK;
-
- return 0;
-}
-
-static struct irq_chip orion5x_gpio_irq_chip = {
- .name = "Orion-IRQ-GPIO",
- .ack = orion5x_gpio_irq_ack,
- .mask = orion5x_gpio_irq_mask,
- .unmask = orion5x_gpio_irq_unmask,
- .set_type = orion5x_gpio_set_irq_type,
-};
-
-static void orion5x_gpio_irq_handler(unsigned int irq, struct irq_desc *desc)
-{
- u32 cause, offs, pin;
-
BUG_ON(irq < IRQ_ORION5X_GPIO_0_7 || irq > IRQ_ORION5X_GPIO_24_31);
- offs = (irq - IRQ_ORION5X_GPIO_0_7) * 8;
- cause = (readl(GPIO_DATA_IN) & readl(GPIO_LEVEL_MASK)) |
- (readl(GPIO_EDGE_CAUSE) & readl(GPIO_EDGE_MASK));
- for (pin = offs; pin < offs + 8; pin++) {
- if (cause & (1 << pin)) {
- irq = gpio_to_irq(pin);
- desc = irq_desc + irq;
- if ((desc->status & IRQ_TYPE_SENSE_MASK) == IRQ_TYPE_EDGE_BOTH) {
- /* Swap polarity (race with GPIO line) */
- u32 polarity = readl(GPIO_IN_POL);
- polarity ^= 1 << pin;
- writel(polarity, GPIO_IN_POL);
- }
- generic_handle_irq(irq);
- }
- }
+ orion_gpio_irq_handler((irq - IRQ_ORION5X_GPIO_0_7) << 3);
}
-static void __init orion5x_init_gpio_irq(void)
+void __init orion5x_init_irq(void)
{
int i;
- struct irq_desc *desc;
+
+ orion_irq_init(0, (void __iomem *)MAIN_IRQ_MASK);
/*
* Mask and clear GPIO IRQ interrupts
*/
- writel(0x0, GPIO_LEVEL_MASK);
- writel(0x0, GPIO_EDGE_MASK);
- writel(0x0, GPIO_EDGE_CAUSE);
+ writel(0x0, GPIO_LEVEL_MASK(0));
+ writel(0x0, GPIO_EDGE_MASK(0));
+ writel(0x0, GPIO_EDGE_CAUSE(0));
/*
* Register chained level handlers for GPIO IRQs by default.
* User can use set_type() if he wants to use edge types handlers.
*/
for (i = IRQ_ORION5X_GPIO_START; i < NR_IRQS; i++) {
- set_irq_chip(i, &orion5x_gpio_irq_chip);
+ set_irq_chip(i, &orion_gpio_irq_level_chip);
set_irq_handler(i, handle_level_irq);
- desc = irq_desc + i;
- desc->status |= IRQ_LEVEL;
+ irq_desc[i].status |= IRQ_LEVEL;
set_irq_flags(i, IRQF_VALID);
}
- set_irq_chained_handler(IRQ_ORION5X_GPIO_0_7, orion5x_gpio_irq_handler);
- set_irq_chained_handler(IRQ_ORION5X_GPIO_8_15, orion5x_gpio_irq_handler);
- set_irq_chained_handler(IRQ_ORION5X_GPIO_16_23, orion5x_gpio_irq_handler);
- set_irq_chained_handler(IRQ_ORION5X_GPIO_24_31, orion5x_gpio_irq_handler);
-}
-
-/*****************************************************************************
- * Orion Main IRQ
- ****************************************************************************/
-static void __init orion5x_init_main_irq(void)
-{
- orion_irq_init(0, (void __iomem *)MAIN_IRQ_MASK);
-}
-
-void __init orion5x_init_irq(void)
-{
- orion5x_init_main_irq();
- orion5x_init_gpio_irq();
+ set_irq_chained_handler(IRQ_ORION5X_GPIO_0_7, gpio_irq_handler);
+ set_irq_chained_handler(IRQ_ORION5X_GPIO_8_15, gpio_irq_handler);
+ set_irq_chained_handler(IRQ_ORION5X_GPIO_16_23, gpio_irq_handler);
+ set_irq_chained_handler(IRQ_ORION5X_GPIO_24_31, gpio_irq_handler);
}
projects / linux-2.6-omap-h63xx.git / blobdiff