comment "OMAP Feature Selections"
+config OMAP_DEBUG_DEVICES
+ bool
+ help
+ For debug cards on TI reference boards.
+
+config OMAP_DEBUG_LEDS
+ bool
+ depends on OMAP_DEBUG_DEVICES
+ default y if LEDS || LEDS_OMAP_DEBUG
+
config OMAP_RESET_CLOCKS
bool "Reset unused clocks during boot"
depends on ARCH_OMAP
probably do not want this option enabled until your
device drivers work properly.
+config OMAP_BOOT_TAG
+ bool "OMAP bootloader information passing"
+ depends on ARCH_OMAP
+ default n
+ help
+ Say Y, if you have a bootloader which passes information
+ about your board and its peripheral configuration.
+
+config OMAP_BOOT_REASON
+ bool "Support for boot reason"
+ depends on OMAP_BOOT_TAG
+ default n
+ help
+ Say Y, if you want to have a procfs entry for reading the boot
+ reason in user-space.
+
+config OMAP_COMPONENT_VERSION
+ bool "Support for component version display"
+ depends on OMAP_BOOT_TAG && PROC_FS
+ default n
+ help
+ Say Y, if you want to have a procfs entry for reading component
+ versions (supplied by the bootloader) in user-space.
+
+config OMAP_GPIO_SWITCH
+ bool "GPIO switch support"
+ default n
+ help
+ Say Y, if you want to have support for reporting of GPIO
+ switches (e.g. cover switches) via sysfs. Your bootloader has
+ to provide information about the switches to the kernel via the
+ ATAG_BOARD mechanism if they're not defined by the board config.
+
config OMAP_MUX
bool "OMAP multiplexing support"
depends on ARCH_OMAP
to change the pin multiplexing setup. When there are no warnings
printed, it's safe to deselect OMAP_MUX for your product.
+config OMAP_STI
+ bool "STI/XTI support"
+ depends on ARCH_OMAP16XX || ARCH_OMAP24XX
+ default n
+
+config OMAP_STI_CONSOLE
+ bool "STI console support"
+ depends on OMAP_STI
+ help
+ This enables a console driver by way of STI/XTI.
+
+config OMAP_MCBSP
+ bool "McBSP support"
+ depends on ARCH_OMAP
+ default y
+ help
+ Say Y here if you want support for the OMAP Multichannel
+ Buffered Serial Port.
+
choice
prompt "System timer"
default OMAP_MPU_TIMER
to data on the serial RX line. This allows you to wake the
system from serial console.
+source "arch/arm/plat-omap/dsp/Kconfig"
+
endmenu
endif