Merge branch 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik...

[linux-2.6-omap-h63xx.git] / drivers / char / Kconfig

diff --git a/drivers/char/Kconfig b/drivers/char/Kconfig
index 2af12fc4511585d4f7aab36b863378eff152764a..24f922f127830ea75880c8e65a5dfe3418599942 100644 (file)
--- a/drivers/char/Kconfig
+++ b/drivers/char/Kconfig
@@ -855,39 +855,6 @@ config TANBAC_TB0219
        depends TANBAC_TB022X
        select GPIO_VR41XX
 
-menu "Ftape, the floppy tape device driver"
-
-config FTAPE
-       tristate "Ftape (QIC-80/Travan) support"
-       depends on BROKEN_ON_SMP && (ALPHA || X86)
-       ---help---
-         If you have a tape drive that is connected to your floppy
-         controller, say Y here.
-
-         Some tape drives (like the Seagate "Tape Store 3200" or the Iomega
-         "Ditto 3200" or the Exabyte "Eagle TR-3") come with a "high speed"
-         controller of their own. These drives (and their companion
-         controllers) are also supported if you say Y here.
-
-         If you have a special controller (such as the CMS FC-10, FC-20,
-         Mountain Mach-II, or any controller that is based on the Intel 82078
-         FDC like the high speed controllers by Seagate and Exabyte and
-         Iomega's "Ditto Dash") you must configure it by selecting the
-         appropriate entries from the "Floppy tape controllers" sub-menu
-         below and possibly modify the default values for the IRQ and DMA
-         channel and the IO base in ftape's configuration menu.
-
-         If you want to use your floppy tape drive on a PCI-bus based system,
-         please read the file <file:drivers/char/ftape/README.PCI>.
-
-         The ftape kernel driver is also available as a runtime loadable
-         module. To compile this driver as a module, choose M here: the
-         module will be called ftape.
-
-source "drivers/char/ftape/Kconfig"
-
-endmenu
-
 source "drivers/char/agp/Kconfig"
 
 source "drivers/char/drm/Kconfig"
@@ -994,7 +961,7 @@ config HPET
        help
          If you say Y here, you will have a miscdevice named "/dev/hpet/".  Each
          open selects one of the timers supported by the HPET.  The timers are
-         non-periodioc and/or periodic.
+         non-periodic and/or periodic.
 
 config HPET_RTC_IRQ
        bool "HPET Control RTC IRQ" if !HPET_EMULATE_RTC