*/
#include <linux/types.h>
-#include <asm/scatterlist.h>
#include <linux/scatterlist.h>
#include <linux/mmc/host.h>
}
err = mmc_wait_for_cmd(host, &cmd, MMC_CMD_RETRIES);
- if (err != MMC_ERR_NONE)
+ if (err)
return err;
- return MMC_ERR_NONE;
+ return 0;
}
int mmc_select_card(struct mmc_card *card)
int err;
struct mmc_command cmd;
- mmc_set_chip_select(host, MMC_CS_HIGH);
-
- mmc_delay(1);
+ /*
+ * Non-SPI hosts need to prevent chipselect going active during
+ * GO_IDLE; that would put chips into SPI mode. Remind them of
+ * that in case of hardware that won't pull up DAT3/nCS otherwise.
+ *
+ * SPI hosts ignore ios.chip_select; it's managed according to
+ * rules that must accomodate non-MMC slaves which this layer
+ * won't even know about.
+ */
+ if (!mmc_host_is_spi(host)) {
+ mmc_set_chip_select(host, MMC_CS_HIGH);
+ mmc_delay(1);
+ }
memset(&cmd, 0, sizeof(struct mmc_command));
cmd.opcode = MMC_GO_IDLE_STATE;
cmd.arg = 0;
- cmd.flags = MMC_RSP_NONE | MMC_CMD_BC;
+ cmd.flags = MMC_RSP_SPI_R1 | MMC_RSP_NONE | MMC_CMD_BC;
err = mmc_wait_for_cmd(host, &cmd, 0);
mmc_delay(1);
- mmc_set_chip_select(host, MMC_CS_DONTCARE);
+ if (!mmc_host_is_spi(host)) {
+ mmc_set_chip_select(host, MMC_CS_DONTCARE);
+ mmc_delay(1);
+ }
- mmc_delay(1);
+ host->use_spi_crc = 0;
return err;
}
memset(&cmd, 0, sizeof(struct mmc_command));
cmd.opcode = MMC_SEND_OP_COND;
- cmd.arg = ocr;
- cmd.flags = MMC_RSP_R3 | MMC_CMD_BCR;
+ cmd.arg = mmc_host_is_spi(host) ? 0 : ocr;
+ cmd.flags = MMC_RSP_SPI_R1 | MMC_RSP_R3 | MMC_CMD_BCR;
for (i = 100; i; i--) {
err = mmc_wait_for_cmd(host, &cmd, 0);
- if (err != MMC_ERR_NONE)
+ if (err)
break;
- if (cmd.resp[0] & MMC_CARD_BUSY || ocr == 0)
+ /* if we're just probing, do a single pass */
+ if (ocr == 0)
break;
- err = MMC_ERR_TIMEOUT;
+ /* otherwise wait until reset completes */
+ if (mmc_host_is_spi(host)) {
+ if (!(cmd.resp[0] & R1_SPI_IDLE))
+ break;
+ } else {
+ if (cmd.resp[0] & MMC_CARD_BUSY)
+ break;
+ }
+
+ err = -ETIMEDOUT;
mmc_delay(10);
}
- if (rocr)
+ if (rocr && !mmc_host_is_spi(host))
*rocr = cmd.resp[0];
return err;
cmd.flags = MMC_RSP_R2 | MMC_CMD_BCR;
err = mmc_wait_for_cmd(host, &cmd, MMC_CMD_RETRIES);
- if (err != MMC_ERR_NONE)
+ if (err)
return err;
memcpy(cid, cmd.resp, sizeof(u32) * 4);
- return MMC_ERR_NONE;
+ return 0;
}
int mmc_set_relative_addr(struct mmc_card *card)
cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
err = mmc_wait_for_cmd(card->host, &cmd, MMC_CMD_RETRIES);
- if (err != MMC_ERR_NONE)
+ if (err)
return err;
- return MMC_ERR_NONE;
+ return 0;
}
-int mmc_send_csd(struct mmc_card *card, u32 *csd)
+static int
+mmc_send_cxd_native(struct mmc_host *host, u32 arg, u32 *cxd, int opcode)
{
int err;
struct mmc_command cmd;
- BUG_ON(!card);
- BUG_ON(!card->host);
- BUG_ON(!csd);
+ BUG_ON(!host);
+ BUG_ON(!cxd);
memset(&cmd, 0, sizeof(struct mmc_command));
- cmd.opcode = MMC_SEND_CSD;
- cmd.arg = card->rca << 16;
+ cmd.opcode = opcode;
+ cmd.arg = arg;
cmd.flags = MMC_RSP_R2 | MMC_CMD_AC;
- err = mmc_wait_for_cmd(card->host, &cmd, MMC_CMD_RETRIES);
- if (err != MMC_ERR_NONE)
+ err = mmc_wait_for_cmd(host, &cmd, MMC_CMD_RETRIES);
+ if (err)
return err;
- memcpy(csd, cmd.resp, sizeof(u32) * 4);
+ memcpy(cxd, cmd.resp, sizeof(u32) * 4);
- return MMC_ERR_NONE;
+ return 0;
}
-int mmc_send_ext_csd(struct mmc_card *card, u8 *ext_csd)
+static int
+mmc_send_cxd_data(struct mmc_card *card, struct mmc_host *host,
+ u32 opcode, void *buf, unsigned len)
{
struct mmc_request mrq;
struct mmc_command cmd;
struct mmc_data data;
struct scatterlist sg;
+ void *data_buf;
- BUG_ON(!card);
- BUG_ON(!card->host);
- BUG_ON(!ext_csd);
+ /* dma onto stack is unsafe/nonportable, but callers to this
+ * routine normally provide temporary on-stack buffers ...
+ */
+ data_buf = kmalloc(len, GFP_KERNEL);
+ if (data_buf == NULL)
+ return -ENOMEM;
memset(&mrq, 0, sizeof(struct mmc_request));
memset(&cmd, 0, sizeof(struct mmc_command));
mrq.cmd = &cmd;
mrq.data = &data;
- cmd.opcode = MMC_SEND_EXT_CSD;
+ cmd.opcode = opcode;
cmd.arg = 0;
- cmd.flags = MMC_RSP_R1 | MMC_CMD_ADTC;
- data.blksz = 512;
+ /* NOTE HACK: the MMC_RSP_SPI_R1 is always correct here, but we
+ * rely on callers to never use this with "native" calls for reading
+ * CSD or CID. Native versions of those commands use the R2 type,
+ * not R1 plus a data block.
+ */
+ cmd.flags = MMC_RSP_SPI_R1 | MMC_RSP_R1 | MMC_CMD_ADTC;
+
+ data.blksz = len;
data.blocks = 1;
data.flags = MMC_DATA_READ;
data.sg = &sg;
data.sg_len = 1;
- sg_init_one(&sg, ext_csd, 512);
+ sg_init_one(&sg, data_buf, len);
+
+ /*
+ * The spec states that CSR and CID accesses have a timeout
+ * of 64 clock cycles.
+ */
+ data.timeout_ns = 0;
+ data.timeout_clks = 64;
- mmc_set_data_timeout(&data, card, 0);
+ mmc_wait_for_req(host, &mrq);
- mmc_wait_for_req(card->host, &mrq);
+ memcpy(buf, data_buf, len);
+ kfree(data_buf);
- if (cmd.error != MMC_ERR_NONE)
+ if (cmd.error)
return cmd.error;
- if (data.error != MMC_ERR_NONE)
+ if (data.error)
return data.error;
- return MMC_ERR_NONE;
+ return 0;
+}
+
+int mmc_send_csd(struct mmc_card *card, u32 *csd)
+{
+ int ret, i;
+
+ if (!mmc_host_is_spi(card->host))
+ return mmc_send_cxd_native(card->host, card->rca << 16,
+ csd, MMC_SEND_CSD);
+
+ ret = mmc_send_cxd_data(card, card->host, MMC_SEND_CSD, csd, 16);
+ if (ret)
+ return ret;
+
+ for (i = 0;i < 4;i++)
+ csd[i] = be32_to_cpu(csd[i]);
+
+ return 0;
+}
+
+int mmc_send_cid(struct mmc_host *host, u32 *cid)
+{
+ int ret, i;
+
+ if (!mmc_host_is_spi(host)) {
+ if (!host->card)
+ return -EINVAL;
+ return mmc_send_cxd_native(host, host->card->rca << 16,
+ cid, MMC_SEND_CID);
+ }
+
+ ret = mmc_send_cxd_data(NULL, host, MMC_SEND_CID, cid, 16);
+ if (ret)
+ return ret;
+
+ for (i = 0;i < 4;i++)
+ cid[i] = be32_to_cpu(cid[i]);
+
+ return 0;
+}
+
+int mmc_send_ext_csd(struct mmc_card *card, u8 *ext_csd)
+{
+ return mmc_send_cxd_data(card, card->host, MMC_SEND_EXT_CSD,
+ ext_csd, 512);
+}
+
+int mmc_spi_read_ocr(struct mmc_host *host, int highcap, u32 *ocrp)
+{
+ struct mmc_command cmd;
+ int err;
+
+ memset(&cmd, 0, sizeof(struct mmc_command));
+
+ cmd.opcode = MMC_SPI_READ_OCR;
+ cmd.arg = highcap ? (1 << 30) : 0;
+ cmd.flags = MMC_RSP_SPI_R3;
+
+ err = mmc_wait_for_cmd(host, &cmd, 0);
+
+ *ocrp = cmd.resp[1];
+ return err;
+}
+
+int mmc_spi_set_crc(struct mmc_host *host, int use_crc)
+{
+ struct mmc_command cmd;
+ int err;
+
+ memset(&cmd, 0, sizeof(struct mmc_command));
+
+ cmd.opcode = MMC_SPI_CRC_ON_OFF;
+ cmd.flags = MMC_RSP_SPI_R1;
+ cmd.arg = use_crc;
+
+ err = mmc_wait_for_cmd(host, &cmd, 0);
+ if (!err)
+ host->use_spi_crc = use_crc;
+ return err;
}
int mmc_switch(struct mmc_card *card, u8 set, u8 index, u8 value)
(index << 16) |
(value << 8) |
set;
- cmd.flags = MMC_RSP_R1B | MMC_CMD_AC;
+ cmd.flags = MMC_RSP_SPI_R1B | MMC_RSP_R1B | MMC_CMD_AC;
err = mmc_wait_for_cmd(card->host, &cmd, MMC_CMD_RETRIES);
- if (err != MMC_ERR_NONE)
+ if (err)
return err;
- return MMC_ERR_NONE;
+ return 0;
}
int mmc_send_status(struct mmc_card *card, u32 *status)
memset(&cmd, 0, sizeof(struct mmc_command));
cmd.opcode = MMC_SEND_STATUS;
- cmd.arg = card->rca << 16;
- cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
+ if (!mmc_host_is_spi(card->host))
+ cmd.arg = card->rca << 16;
+ cmd.flags = MMC_RSP_SPI_R2 | MMC_RSP_R1 | MMC_CMD_AC;
err = mmc_wait_for_cmd(card->host, &cmd, MMC_CMD_RETRIES);
- if (err != MMC_ERR_NONE)
+ if (err)
return err;
+ /* NOTE: callers are required to understand the difference
+ * between "native" and SPI format status words!
+ */
if (status)
*status = cmd.resp[0];
- return MMC_ERR_NONE;
+ return 0;
}
projects / linux-2.6-omap-h63xx.git / blobdiff