*/
static void __devinit quirk_vt82c586_acpi(struct pci_dev *dev)
{
- u8 rev;
u32 region;
- pci_read_config_byte(dev, PCI_CLASS_REVISION, &rev);
- if (rev & 0x10) {
+ if (dev->revision & 0x10) {
pci_read_config_dword(dev, 0x48, ®ion);
region &= PCI_BASE_ADDRESS_IO_MASK;
quirk_io_region(dev, region, 256, PCI_BRIDGE_RESOURCES, "vt82c586 ACPI");
*/
static void __init quirk_amd_8131_mmrbc(struct pci_dev *dev)
{
- unsigned char revid;
-
- pci_read_config_byte(dev, PCI_REVISION_ID, &revid);
- if (dev->subordinate && revid <= 0x12) {
+ if (dev->subordinate && dev->revision <= 0x12) {
printk(KERN_INFO "AMD8131 rev %x detected, disabling PCI-X "
- "MMRBC\n", revid);
+ "MMRBC\n", dev->revision);
dev->subordinate->bus_flags |= PCI_BUS_FLAGS_NO_MMRBC;
}
}
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82375, quirk_eisa_bridge );
-/*
- * On the MSI-K8T-Neo2Fir Board, the internal Soundcard is disabled
- * when a PCI-Soundcard is added. The BIOS only gives Options
- * "Disabled" and "AUTO". This Quirk Sets the corresponding
- * Register-Value to enable the Soundcard.
- *
- * FIXME: Presently this quirk will run on anything that has an 8237
- * which isn't correct, we need to check DMI tables or something in
- * order to make sure it only runs on the MSI-K8T-Neo2Fir. Because it
- * runs everywhere at present we suppress the printk output in most
- * irrelevant cases.
- */
-static void k8t_sound_hostbridge(struct pci_dev *dev)
-{
- unsigned char val;
-
- pci_read_config_byte(dev, 0x50, &val);
- if (val == 0xc8) {
- /* Assume it's probably a MSI-K8T-Neo2Fir */
- printk(KERN_INFO "PCI: MSI-K8T-Neo2Fir, attempting to turn soundcard ON\n");
- pci_write_config_byte(dev, 0x50, val & (~0x40));
-
- /* Verify the Change for Status output */
- pci_read_config_byte(dev, 0x50, &val);
- if (val & 0x40)
- printk(KERN_INFO "PCI: MSI-K8T-Neo2Fir, soundcard still off\n");
- else
- printk(KERN_INFO "PCI: MSI-K8T-Neo2Fir, soundcard on\n");
- }
-}
-DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_8237, k8t_sound_hostbridge);
-DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_8237, k8t_sound_hostbridge);
/*
* On ASUS P4B boards, the SMBus PCI Device within the ICH2/4 southbridge
*
* The SMBus PCI Device can be activated by setting a bit in the ICH LPC
* bridge. Unfortunately, this device has no subvendor/subdevice ID. So it
- * becomes necessary to do this tweak in two steps -- I've chosen the Host
- * bridge as trigger.
+ * becomes necessary to do this tweak in two steps -- the chosen trigger
+ * is either the Host bridge (preferred) or on-board VGA controller.
*
* Note that we used to unhide the SMBus that way on Toshiba laptops
* (Satellite A40 and Tecra M2) but then found that the thermal management
case 0x0058: /* Compaq Evo N620c */
asus_hides_smbus = 1;
}
+ else if (dev->device == PCI_DEVICE_ID_INTEL_82810_IG3)
+ switch(dev->subsystem_device) {
+ case 0xB16C: /* Compaq Deskpro EP 401963-001 (PCA# 010174) */
+ /* Motherboard doesn't have Host bridge
+ * subvendor/subdevice IDs, therefore checking
+ * its on-board VGA controller */
+ asus_hides_smbus = 1;
+ }
}
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82845_HB, asus_hides_smbus_hostbridge );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82855GM_HB, asus_hides_smbus_hostbridge );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82915GM_HB, asus_hides_smbus_hostbridge );
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82810_IG3, asus_hides_smbus_hostbridge );
+
static void asus_hides_smbus_lpc(struct pci_dev *dev)
{
u16 val;
printk(KERN_INFO "PCI: Enabled i801 SMBus device\n");
}
}
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801AA_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801DB_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801BA_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_12, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801DB_12, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801EB_0, asus_hides_smbus_lpc );
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801AA_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801DB_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801BA_0, asus_hides_smbus_lpc );
DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801CA_0, asus_hides_smbus_lpc );
case PCI_DEVICE_ID_JMICRON_JMB363:
/* Enable dual function mode, AHCI on fn 0, IDE fn1 */
/* Set the class codes correctly and then direct IDE 0 */
- conf1 |= 0x00C2A102; /* Set 1, 8, 13, 15, 17, 22, 23 */
+ conf1 |= 0x00C2A1B3; /* Set 0, 1, 4, 5, 7, 8, 13, 15, 17, 22, 23 */
break;
case PCI_DEVICE_ID_JMICRON_JMB368:
static void __devinit quirk_e100_interrupt(struct pci_dev *dev)
{
u16 command;
- u32 bar;
u8 __iomem *csr;
u8 cmd_hi;
* re-enable them when it's ready.
*/
pci_read_config_word(dev, PCI_COMMAND, &command);
- pci_read_config_dword(dev, PCI_BASE_ADDRESS_0, &bar);
- if (!(command & PCI_COMMAND_MEMORY) || !bar)
+ if (!(command & PCI_COMMAND_MEMORY) || !pci_resource_start(dev, 0))
return;
- csr = ioremap(bar, 8);
+ /* Convert from PCI bus to resource space. */
+ csr = ioremap(pci_resource_start(dev, 0), 8);
if (!csr) {
printk(KERN_WARNING "PCI: Can't map %s e100 registers\n",
pci_name(dev));