#define AP_QID_QUEUE(_qid) ((_qid) & 15)
/**
+ * structy ap_queue_status - Holds the AP queue status.
+ * @queue_empty: Shows if queue is empty
+ * @replies_waiting: Waiting replies
+ * @queue_full: Is 1 if the queue is full
+ * @pad: A 4 bit pad
+ * @int_enabled: Shows if interrupts are enabled for the AP
+ * @response_conde: Holds the 8 bit response code
+ * @pad2: A 16 bit pad
+ *
* The ap queue status word is returned by all three AP functions
* (PQAP, NQAP and DQAP). There's a set of flags in the first
* byte, followed by a 1 byte response code.
#define AP_RESPONSE_NO_FIRST_PART 0x13
#define AP_RESPONSE_MESSAGE_TOO_BIG 0x15
-/**
+/*
* Known device types
*/
#define AP_DEVICE_TYPE_PCICC 3
#define AP_DEVICE_TYPE_CEX2A 6
#define AP_DEVICE_TYPE_CEX2C 7
-/**
+/*
* AP reset flag states
*/
#define AP_RESET_IGNORE 0 /* request timeout will be ignored */
.dev_type=(dt), \
.match_flags=AP_DEVICE_ID_MATCH_DEVICE_TYPE,
-/**
+/*
* Note: don't use ap_send/ap_recv after using ap_queue_message
* for the first time. Otherwise the ap message queue will get
* confused.