# fully appropriate there, so it'd need some thought to do well.
#
menu "SPI support"
+ depends on HAS_IOMEM
config SPI
bool "SPI support"
This selects a driver for the Atmel SPI Controller, present on
many AT32 (AVR32) and AT91 (ARM) chips.
+config SPI_BFIN
+ tristate "SPI controller driver for ADI Blackfin5xx"
+ depends on SPI_MASTER && BFIN
+ help
+ This is the SPI controller master driver for Blackfin 5xx processor.
+
+config SPI_AU1550
+ tristate "Au1550/Au12x0 SPI Controller"
+ depends on SPI_MASTER && (SOC_AU1550 || SOC_AU1200) && EXPERIMENTAL
+ select SPI_BITBANG
+ help
+ If you say yes to this option, support will be included for the
+ Au1550 SPI controller (may also work with Au1200,Au1210,Au1250).
+
+ This driver can also be built as a module. If so, the module
+ will be called au1550_spi.
+
config SPI_BITBANG
tristate "Bitbanging SPI master"
depends on SPI_MASTER && EXPERIMENTAL
This enables using the Freescale iMX SPI controller in master
mode.
+config SPI_MPC52xx_PSC
+ tristate "Freescale MPC52xx PSC SPI controller"
+ depends on SPI_MASTER && PPC_MPC52xx && EXPERIMENTAL
+ help
+ This enables using the Freescale MPC52xx Programmable Serial
+ Controller in master SPI mode.
+
config SPI_MPC83xx
tristate "Freescale MPC83xx SPI controller"
depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL
help
This hooks up to the MicroWire controller on OMAP1 chips.
+config SPI_OMAP24XX
+ bool "McSPI driver for OMAP24xx"
+ depends on SPI_MASTER && ARCH_OMAP24XX
+ help
+ SPI master controller for OMAP24xx McSPI modules.
config SPI_PXA2XX
tristate "PXA2xx SSP SPI master"
This driver can also be built as a module. If so, the module
will be called at25.
+config SPI_SPIDEV
+ tristate "User mode SPI device driver support"
+ depends on SPI_MASTER && EXPERIMENTAL
+ help
+ This supports user mode SPI protocol drivers.
+
+ Note that this application programming interface is EXPERIMENTAL
+ and hence SUBJECT TO CHANGE WITHOUT NOTICE while it stabilizes.
+
#
# Add new SPI protocol masters in alphabetical order above this line
#
-
# (slave support would go here)
endmenu # "SPI support"