[WATCHDOG] pcwd.c Control Status #2 patch

[linux-2.6-omap-h63xx.git] / drivers / w1 / Kconfig

diff --git a/drivers/w1/Kconfig b/drivers/w1/Kconfig
index 2ab65c902fe58a3c151bf7421a3d78c5553cf7a6..4baf61a22327dd9400d00d9c27ec57fe1cef3235 100644 (file)
--- a/drivers/w1/Kconfig
+++ b/drivers/w1/Kconfig
@@ -3,9 +3,9 @@ menu "Dallas's 1-wire bus"
 config W1
        tristate "Dallas's 1-wire support"
        ---help---
-         Dallas's 1-wire bus is usefull to connect slow 1-pin devices 
+         Dallas's 1-wire bus is useful to connect slow 1-pin devices
          such as iButtons and thermal sensors.
-         
+
          If you want W1 support, you should say Y here.
 
          This W1 support can also be built as a module.  If so, the module
@@ -17,8 +17,8 @@ config W1_MATROX
        help
          Say Y here if you want to communicate with your 1-wire devices
          using Matrox's G400 GPIO pins.
-         
-         This support is also available as a module.  If so, the module 
+
+         This support is also available as a module.  If so, the module
          will be called matrox_w1.ko.
 
 config W1_DS9490
@@ -27,7 +27,7 @@ config W1_DS9490
        help
          Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge.
 
-         This support is also available as a module.  If so, the module 
+         This support is also available as a module.  If so, the module
          will be called ds9490r.ko.
 
 config W1_DS9490_BRIDGE
@@ -37,7 +37,7 @@ config W1_DS9490_BRIDGE
          Say Y here if you want to communicate with your 1-wire devices
          using DS9490R USB bridge.
 
-         This support is also available as a module.  If so, the module 
+         This support is also available as a module.  If so, the module
          will be called ds_w1_bridge.ko.
 
 config W1_THERM
@@ -51,7 +51,23 @@ config W1_SMEM
        tristate "Simple 64bit memory family implementation"
        depends on W1
        help
-         Say Y here if you want to connect 1-wire 
+         Say Y here if you want to connect 1-wire
          simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire.
 
+config W1_DS2433
+       tristate "4kb EEPROM family support (DS2433)"
+       depends on W1
+       help
+         Say Y here if you want to use a 1-wire
+         4kb EEPROM family device (DS2433).
+
+config W1_DS2433_CRC
+       bool "Protect DS2433 data with a CRC16"
+       depends on W1_DS2433
+       select CRC16
+       help
+         Say Y here to protect DS2433 data with a CRC16.
+         Each block has 30 bytes of data and a two byte CRC16.
+         Full block writes are only allowed if the CRC is valid.
+
 endmenu