struct regulator_dev;
struct regulator_init_data;
+enum regulator_status {
+ REGULATOR_STATUS_OFF,
+ REGULATOR_STATUS_ON,
+ REGULATOR_STATUS_ERROR,
+ /* fast/normal/idle/standby are flavors of "on" */
+ REGULATOR_STATUS_FAST,
+ REGULATOR_STATUS_NORMAL,
+ REGULATOR_STATUS_IDLE,
+ REGULATOR_STATUS_STANDBY,
+};
+
/**
* struct regulator_ops - regulator operations.
*
- * This struct describes regulator operations.
+ * This struct describes regulator operations which can be implemented by
+ * regulator chip drivers.
+ *
+ * @enable: Enable the regulator.
+ * @disable: Disable the regulator.
+ * @is_enabled: Return 1 if the regulator is enabled, 0 otherwise.
+ *
+ * @set_voltage: Set the voltage for the regulator within the range specified.
+ * The driver should select the voltage closest to min_uV.
+ * @get_voltage: Return the currently configured voltage for the regulator.
+ *
+ * @set_current_limit: Configure a limit for a current-limited regulator.
+ * @get_current_limit: Get the limit for a current-limited regulator.
+ *
+ * @set_mode: Set the operating mode for the regulator.
+ * @get_mode: Get the current operating mode for the regulator.
+ * @get_optimum_mode: Get the most efficient operating mode for the regulator
+ * when running with the specified parameters.
+ *
+ * @set_suspend_voltage: Set the voltage for the regulator when the system
+ * is suspended.
+ * @set_suspend_enable: Mark the regulator as enabled when the system is
+ * suspended.
+ * @set_suspend_disable: Mark the regulator as disabled when the system is
+ * suspended.
+ * @set_suspend_mode: Set the operating mode for the regulator when the
+ * system is suspended.
*/
struct regulator_ops {
int (*set_mode) (struct regulator_dev *, unsigned int mode);
unsigned int (*get_mode) (struct regulator_dev *);
+ /* report regulator status ... most other accessors report
+ * control inputs, this reports results of combining inputs
+ * from Linux (and other sources) with the actual load.
+ */
+ int (*get_status)(struct regulator_dev *);
+
/* get most efficient regulator operating mode for load */
unsigned int (*get_optimum_mode) (struct regulator_dev *, int input_uV,
int output_uV, int load_uA);
/**
* struct regulator_desc - Regulator descriptor
*
+ * Each regulator registered with the core is described with a structure of
+ * this type.
+ *
+ * @name: Identifying name for the regulator.
+ * @id: Numerical identifier for the regulator.
+ * @ops: Regulator operations table.
+ * @irq: Interrupt number for the regulator.
+ * @type: Indicates if the regulator is a voltage or current regulator.
+ * @owner: Module providing the regulator, used for refcounting.
*/
struct regulator_desc {
const char *name;