struct regulator_dev;
struct regulator_init_data;
+enum regulator_status {
+ REGULATOR_STATUS_OFF,
+ REGULATOR_STATUS_ON,
+ REGULATOR_STATUS_ERROR,
+ /* fast/normal/idle/standby are flavors of "on" */
+ REGULATOR_STATUS_FAST,
+ REGULATOR_STATUS_NORMAL,
+ REGULATOR_STATUS_IDLE,
+ REGULATOR_STATUS_STANDBY,
+};
+
/**
* struct regulator_ops - regulator operations.
*
* @set_voltage: Set the voltage for the regulator within the range specified.
* The driver should select the voltage closest to min_uV.
* @get_voltage: Return the currently configured voltage for the regulator.
+ * @list_voltage: Return one of the supported voltages, in microvolts; zero
+ * if the selector indicates a voltage that is unusable on this system;
+ * or negative errno. Selectors range from zero to one less than
+ * regulator_desc.n_voltages. Voltages may be reported in any order.
*
* @set_current_limit: Configure a limit for a current-limited regulator.
* @get_current_limit: Get the limit for a current-limited regulator.
*/
struct regulator_ops {
+ /* enumerate supported voltages */
+ int (*list_voltage) (struct regulator_dev *, unsigned selector);
+
/* get/set regulator voltage */
int (*set_voltage) (struct regulator_dev *, int min_uV, int max_uV);
int (*get_voltage) (struct regulator_dev *);
int (*set_mode) (struct regulator_dev *, unsigned int mode);
unsigned int (*get_mode) (struct regulator_dev *);
+ /* report regulator status ... most other accessors report
+ * control inputs, this reports results of combining inputs
+ * from Linux (and other sources) with the actual load.
+ */
+ int (*get_status)(struct regulator_dev *);
+
/* get most efficient regulator operating mode for load */
unsigned int (*get_optimum_mode) (struct regulator_dev *, int input_uV,
int output_uV, int load_uA);
*
* @name: Identifying name for the regulator.
* @id: Numerical identifier for the regulator.
+ * @n_voltages: Number of selectors available for ops.list_voltage().
* @ops: Regulator operations table.
* @irq: Interrupt number for the regulator.
* @type: Indicates if the regulator is a voltage or current regulator.
struct regulator_desc {
const char *name;
int id;
+ unsigned n_voltages;
struct regulator_ops *ops;
int irq;
enum regulator_type type;