struct isp116x_platform_data {
/* Enable internal resistors on downstream ports */
unsigned sel15Kres:1;
- /* Chip's internal clock won't be stopped in suspended state.
- Setting/unsetting this bit takes effect only if
- 'remote_wakeup_enable' below is not set. */
- unsigned clknotstop:1;
- /* On-chip overcurrent protection */
+ /* On-chip overcurrent detection */
unsigned oc_enable:1;
/* INT output polarity */
unsigned int_act_high:1;
/* INT edge or level triggered */
unsigned int_edge_triggered:1;
- /* WAKEUP pin connected - NOT SUPPORTED */
- /* unsigned remote_wakeup_connected:1; */
- /* Wakeup by devices on usb bus enabled */
+ /* Enable wakeup by devices on usb bus (e.g. wakeup
+ by attachment/detachment or by device activity
+ such as moving a mouse). When chosen, this option
+ prevents stopping internal clock, increasing
+ thereby power consumption in suspended state. */
unsigned remote_wakeup_enable:1;
- /* Switch or not to switch (keep always powered) */
- unsigned no_power_switching:1;
- /* Ganged port power switching (0) or individual port
- power switching (1) */
- unsigned power_switching_mode:1;
- /* Given port_power, msec/2 after power on till power good */
- u8 potpg;
- /* Hardware reset set/clear. If implemented, this function must:
- if set == 0, deassert chip's HW reset pin
- otherwise, assert chip's HW reset pin */
- void (*reset) (struct device * dev, int set);
- /* Hardware clock start/stop. If implemented, this function must:
- if start == 0, stop the external clock
- otherwise, start the external clock
- */
- void (*clock) (struct device * dev, int start);
/* Inter-io delay (ns). The chip is picky about access timings; it
expects at least:
150ns delay between consecutive accesses to DATA_REG,