#define FXRT_CHANNELC 0x0f000000 /* Effects send bus number for channel's effects send C */
#define FXRT_CHANNELD 0xf0000000 /* Effects send bus number for channel's effects send D */
+#define A_HR 0x0b /* High Resolution. 24bit playback from host to DSP. */
#define MAPA 0x0c /* Cache map A */
#define MAPB 0x0d /* Cache map B */
#define MAP_PTE_MASK 0xffffe000 /* The 19 MSBs of the PTE indexed by the PTI */
#define MAP_PTI_MASK 0x00001fff /* The 13 bit index to one of the 8192 PTE dwords */
+/* 0x0e, 0x0f: Not used */
+
#define ENVVOL 0x10 /* Volume envelope register */
#define ENVVOL_MASK 0x0000ffff /* Current value of volume envelope state variable */
/* 0x8000-n == 666*n usec delay */
/* NOTE: All channels contain internal variables; do */
/* not write to these locations. */
-/* 1f something */
+/* 0x1f: not used */
#define CD0 0x20 /* Cache data 0 register */
#define CD1 0x21 /* Cache data 1 register */
#define FXWC_SPDIFLEFT (1<<22) /* 0x00400000 */
#define FXWC_SPDIFRIGHT (1<<23) /* 0x00800000 */
+#define A_TBLSZ ` 0x43 /* Effects Tank Internal Table Size. Only low byte or register used */
+
#define TCBS 0x44 /* Tank cache buffer size register */
#define TCBS_MASK 0x00000007 /* Tank cache buffer size field */
#define TCBS_BUFFSIZE_16K 0x00000000
#define FXBA 0x47 /* FX Buffer Address */
#define FXBA_MASK 0xfffff000 /* 20 bit base address */
-/* 0x48 something - word access, defaults to 3f */
+#define A_HWM 0x48 /* High PCI Water Mark - word access, defaults to 3f */
#define MICBS 0x49 /* Microphone buffer size register */
#define ADCBS_BUFSIZE_57344 0x0000001e
#define ADCBS_BUFSIZE_65536 0x0000001f
+/* Current Send B, A Amounts */
+#define A_CSBA 0x4c
+
+/* Current Send D, C Amounts */
+#define A_CSDC 0x4d
+
+/* Current Send F, E Amounts */
+#define A_CSFE 0x4e
+
+/* Current Send H, G Amounts */
+#define A_CSHG 0x4f
+
#define CDCS 0x50 /* CD-ROM digital channel status register */
#define DBG 0x52 /* DO NOT PROGRAM THIS REGISTER!!! MAY DESTROY CHIP */
+/* S/PDIF Input C Channel Status */
+#define A_SPSC 0x52
+
#define REG53 0x53 /* DO NOT PROGRAM THIS REGISTER!!! MAY DESTROY CHIP */
#define A_DBG 0x53
#define SPCS_NOTAUDIODATA 0x00000002 /* 0 = Digital audio, 1 = not audio */
#define SPCS_PROFESSIONAL 0x00000001 /* 0 = Consumer (IEC-958), 1 = pro (AES3-1992) */
+/* 0x57: Not used */
+
/* The 32-bit CLIx and SOLx registers all have one bit per channel control/status */
#define CLIEL 0x58 /* Channel loop interrupt enable low register */
#define AC97SLOT_CNTR 0x10 /* Center enable */
#define AC97SLOT_LFE 0x20 /* LFE enable */
+/* PCB Revision */
+#define A_PCB 0x5f
+
// NOTE: 0x60,61,62: 64-bit
#define CDSRCS 0x60 /* CD-ROM Sample Rate Converter status register */
#define HLIPH 0x69 /* Channel half loop interrupt pending high register */
-// 0x6a,6b,6c used for some recording
-// 0x6d unused
-// 0x6e,6f - tanktable base / offset
+/* S/PDIF Host Record Index (bypasses SRC) */
+#define A_SPRI 0x6a
+/* S/PDIF Host Record Address */
+#define A_SPRA 0x6b
+/* S/PDIF Host Record Control */
+#define A_SPRC 0x6c
+/* Delayed Interrupt Counter & Enable */
+#define A_DICE 0x6d
+/* Tank Table Base */
+#define A_TTB 0x6e
+/* Tank Delay Offset */
+#define A_TDOF 0x6f
/* This is the MPU port on the card (via the game port) */
#define A_MUDATA1 0x70
#define A_FXWC1 0x74 /* Selects 0x7f-0x60 for FX recording */
#define A_FXWC2 0x75 /* Selects 0x9f-0x80 for FX recording */
+/* Extended Hardware Control */
#define A_SPDIF_SAMPLERATE 0x76 /* Set the sample rate of SPDIF output */
#define A_SAMPLE_RATE 0x76 /* Various sample rate settings. */
#define A_SAMPLE_RATE_NOT_USED 0x0ffc111e /* Bits that are not used and cannot be set. */
#define A_PCM_96000 0x00004000
#define A_PCM_44100 0x00008000
-/* 0x77,0x78,0x79 "something i2s-related" - default to 0x01080000 on my audigy 2 ZS --rlrevell */
-/* 0x7a, 0x7b - lookup tables */
+/* I2S0 Sample Rate Tracker Status */
+#define A_SRT3 0x77
+
+/* I2S1 Sample Rate Tracker Status */
+#define A_SRT4 0x78
+
+/* I2S2 Sample Rate Tracker Status */
+#define A_SRT5 0x79
+/* - default to 0x01080000 on my audigy 2 ZS --rlrevell */
+
+/* Tank Table DMA Address */
+#define A_TTDA 0x7a
+/* Tank Table DMA Data */
+#define A_TTDD 0x7b
#define A_FXRT2 0x7c
#define A_FXRT_CHANNELE 0x0000003f /* Effects send bus number for channel's effects send E */
#define A_FXRT_CHANNELC 0x003f0000
#define A_FXRT_CHANNELD 0x3f000000
-
+/* 0x7f: Not used */
/* Each FX general purpose register is 32 bits in length, all bits are used */
#define FXGPREGBASE 0x100 /* FX general purpose registers base */
#define A_FXGPREGBASE 0x400 /* Audigy GPRs, 0x400 to 0x5ff */
unsigned int input_source[64];
unsigned int adc_pads; /* bit mask */
unsigned int dac_pads; /* bit mask */
+ unsigned int internal_clock; /* 44100 or 48000 */
};
struct snd_emu10k1 {
unsigned int tos_link: 1, /* tos link detected */
rear_ac97: 1, /* rear channels are on AC'97 */
enable_ir: 1;
+ unsigned int support_tlv :1;
/* Contains profile of card capabilities */
const struct snd_emu_chip_details *card_capabilities;
unsigned int audigy; /* is Audigy? */
spinlock_t memblk_lock;
unsigned int spdif_bits[3]; /* s/pdif out setup */
+ unsigned int i2c_capture_source;
+ u8 i2c_capture_volume[4][2];
struct snd_emu10k1_fx8010 fx8010; /* FX8010 info */
int gpr_base;
unsigned int snd_emu10k1_ptr20_read(struct snd_emu10k1 * emu, unsigned int reg, unsigned int chn);
void snd_emu10k1_ptr20_write(struct snd_emu10k1 *emu, unsigned int reg, unsigned int chn, unsigned int data);
int snd_emu10k1_spi_write(struct snd_emu10k1 * emu, unsigned int data);
+int snd_emu10k1_i2c_write(struct snd_emu10k1 *emu, u32 reg, u32 value);
int snd_emu1010_fpga_write(struct snd_emu10k1 * emu, int reg, int value);
int snd_emu1010_fpga_read(struct snd_emu10k1 * emu, int reg, int *value);
int snd_emu1010_fpga_link_dst_src_write(struct snd_emu10k1 * emu, int dst, int src);
unsigned int value[32]; /* initial values */
unsigned int min; /* minimum range */
unsigned int max; /* maximum range */
- union {
- snd_kcontrol_tlv_rw_t *c;
- unsigned int *p;
- } tlv;
unsigned int translation; /* translation type (EMU10K1_GPR_TRANSLATION*) */
+ const unsigned int *tlv;
+};
+
+/* old ABI without TLV support */
+struct snd_emu10k1_fx8010_control_old_gpr {
+ struct snd_ctl_elem_id id;
+ unsigned int vcount;
+ unsigned int count;
+ unsigned short gpr[32];
+ unsigned int value[32];
+ unsigned int min;
+ unsigned int max;
+ unsigned int translation;
};
struct snd_emu10k1_fx8010_code {
unsigned int res2; /* reserved */
};
+#define SNDRV_EMU10K1_VERSION SNDRV_PROTOCOL_VERSION(1, 0, 1)
+
#define SNDRV_EMU10K1_IOCTL_INFO _IOR ('H', 0x10, struct snd_emu10k1_fx8010_info)
#define SNDRV_EMU10K1_IOCTL_CODE_POKE _IOW ('H', 0x11, struct snd_emu10k1_fx8010_code)
#define SNDRV_EMU10K1_IOCTL_CODE_PEEK _IOWR('H', 0x12, struct snd_emu10k1_fx8010_code)
#define SNDRV_EMU10K1_IOCTL_TRAM_PEEK _IOWR('H', 0x22, struct snd_emu10k1_fx8010_tram)
#define SNDRV_EMU10K1_IOCTL_PCM_POKE _IOW ('H', 0x30, struct snd_emu10k1_fx8010_pcm_rec)
#define SNDRV_EMU10K1_IOCTL_PCM_PEEK _IOWR('H', 0x31, struct snd_emu10k1_fx8010_pcm_rec)
+#define SNDRV_EMU10K1_IOCTL_PVERSION _IOR ('H', 0x40, int)
#define SNDRV_EMU10K1_IOCTL_STOP _IO ('H', 0x80)
#define SNDRV_EMU10K1_IOCTL_CONTINUE _IO ('H', 0x81)
#define SNDRV_EMU10K1_IOCTL_ZERO_TRAM_COUNTER _IO ('H', 0x82)
projects / linux-2.6-omap-h63xx.git / blobdiff