tasklet_enable(&local->tasklet);
}
+ /*
+ * set_multicast_list will be invoked by the networking core
+ * which will check whether any increments here were done in
+ * error and sync them down to the hardware as filter flags.
+ */
+ if (sdata->flags & IEEE80211_SDATA_ALLMULTI)
+ atomic_inc(&local->iff_allmultis);
+
+ if (sdata->flags & IEEE80211_SDATA_PROMISC)
+ atomic_inc(&local->iff_promiscs);
+
local->open_count++;
netif_start_queue(dev);
netif_stop_queue(dev);
+ /*
+ * Don't count this interface for promisc/allmulti while it
+ * is down. dev_mc_unsync() will invoke set_multicast_list
+ * on the master interface which will sync these down to the
+ * hardware as filter flags.
+ */
+ if (sdata->flags & IEEE80211_SDATA_ALLMULTI)
+ atomic_dec(&local->iff_allmultis);
+
+ if (sdata->flags & IEEE80211_SDATA_PROMISC)
+ atomic_dec(&local->iff_promiscs);
+
dev_mc_unsync(local->mdev, dev);
/* down all dependent devices, that is VLANs */
allmulti = !!(dev->flags & IFF_ALLMULTI);
promisc = !!(dev->flags & IFF_PROMISC);
- sdata_allmulti = sdata->flags & IEEE80211_SDATA_ALLMULTI;
- sdata_promisc = sdata->flags & IEEE80211_SDATA_PROMISC;
+ sdata_allmulti = !!(sdata->flags & IEEE80211_SDATA_ALLMULTI);
+ sdata_promisc = !!(sdata->flags & IEEE80211_SDATA_PROMISC);
if (allmulti != sdata_allmulti) {
if (dev->flags & IFF_ALLMULTI)
ieee80211_debugfs_add_netdev(IEEE80211_DEV_TO_SUB_IF(local->mdev));
ieee80211_if_set_type(local->mdev, IEEE80211_IF_TYPE_AP);
- result = ieee80211_init_rate_ctrl_alg(local, NULL);
+ result = ieee80211_init_rate_ctrl_alg(local,
+ hw->rate_control_algorithm);
if (result < 0) {
printk(KERN_DEBUG "%s: Failed to initialize rate control "
"algorithm\n", wiphy_name(local->hw.wiphy));
BUILD_BUG_ON(sizeof(struct ieee80211_tx_packet_data) > sizeof(skb->cb));
+#ifdef CONFIG_MAC80211_RCSIMPLE
+ ret = ieee80211_rate_control_register(&mac80211_rcsimple);
+ if (ret)
+ return ret;
+#endif
+
ret = ieee80211_wme_register();
if (ret) {
+#ifdef CONFIG_MAC80211_RCSIMPLE
+ ieee80211_rate_control_unregister(&mac80211_rcsimple);
+#endif
printk(KERN_DEBUG "ieee80211_init: failed to "
"initialize WME (err=%d)\n", ret);
return ret;
static void __exit ieee80211_exit(void)
{
+#ifdef CONFIG_MAC80211_RCSIMPLE
+ ieee80211_rate_control_unregister(&mac80211_rcsimple);
+#endif
+
ieee80211_wme_unregister();
ieee80211_debugfs_netdev_exit();
}