X-Git-Url: http://pilppa.org/gitweb/?a=blobdiff_plain;f=drivers%2Fusb%2Fhost%2FKconfig;h=f3a75a929e0aa26dcdbaee0c75c0cfa10403f8bf;hb=4d41e121664893e5e338f41fbd36be4a2578c8d6;hp=56f592dc0b3626139f4e9b34dd191af967f30bf0;hpb=86d758ef2cb0677b471a88ffe33a29cdfec4ceca;p=linux-2.6-omap-h63xx.git

diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 56f592dc0b3..f3a75a929e0 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -110,29 +110,18 @@ config USB_ISP116X_HCD
 
 config USB_ISP1760_HCD
 	tristate "ISP 1760 HCD support"
-	depends on USB && EXPERIMENTAL
+	depends on USB && EXPERIMENTAL && (PCI || PPC_OF)
 	---help---
 	  The ISP1760 chip is a USB 2.0 host controller.
 
 	  This driver does not support isochronous transfers or OTG.
+	  This USB controller is usually attached to a non-DMA-Master
+	  capable bus. NXP's eval kit brings this chip on PCI card
+	  where the chip itself is behind a PLB to simulate such
+	  a bus.
 
 	  To compile this driver as a module, choose M here: the
-	  module will be called isp1760-hcd.
-
-config USB_ISP1760_PCI
-	bool "Support for the PCI bus"
-	depends on USB_ISP1760_HCD && PCI
-	---help---
-	  Enables support for the device present on the PCI bus.
-	  This should only be required if you happen to have the eval kit from
-	  NXP and you are going to test it.
-
-config USB_ISP1760_OF
-	bool "Support for the OF platform bus"
-	depends on USB_ISP1760_HCD && PPC_OF
-	---help---
-	  Enables support for the device present on the PowerPC
-	  OpenFirmware platform bus.
+	  module will be called isp1760.
 
 config USB_OHCI_HCD
 	tristate "OHCI HCD support"