X-Git-Url: http://pilppa.org/gitweb/?a=blobdiff_plain;f=sound%2Fpci%2Fintel8x0.c;h=9c1bce7afa867b169a33271b0b053bbce7ebf830;hb=bdbf77d6707a52bdeff223d0a60df12d086d21d7;hp=6874263f1681f0dd01475ee8871b363e9a0713e4;hpb=20f99dcf417a28089ef6c877ae97f5dec2eab435;p=linux-2.6-omap-h63xx.git

diff --git a/sound/pci/intel8x0.c b/sound/pci/intel8x0.c
index 6874263f168..9c1bce7afa8 100644
--- a/sound/pci/intel8x0.c
+++ b/sound/pci/intel8x0.c
@@ -801,7 +801,7 @@ static inline void snd_intel8x0_update(struct intel8x0 *chip, struct ichdev *ich
 		 status & (ICH_FIFOE | ICH_BCIS | ICH_LVBCI));
 }
 
-static irqreturn_t snd_intel8x0_interrupt(int irq, void *dev_id, struct pt_regs *regs)
+static irqreturn_t snd_intel8x0_interrupt(int irq, void *dev_id)
 {
 	struct intel8x0 *chip = dev_id;
 	struct ichdev *ichdev;
@@ -1961,6 +1961,12 @@ static struct ac97_quirk ac97_quirks[] __devinitdata = {
 		.name = "Tyan Thunder K8WE",
 		.type = AC97_TUNE_HP_ONLY
 	},
+	{
+		.subvendor = 0x10f7,
+		.subdevice = 0x834c,
+		.name = "Panasonic CF-R4",
+		.type = AC97_TUNE_HP_ONLY,
+	},
 	{
 		.subvendor = 0x110a,
 		.subdevice = 0x0056,
@@ -2251,6 +2257,16 @@ static int snd_intel8x0_ich_chip_init(struct intel8x0 *chip, int probing)
 	/* ACLink on, 2 channels */
 	cnt = igetdword(chip, ICHREG(GLOB_CNT));
 	cnt &= ~(ICH_ACLINK | ICH_PCM_246_MASK);
+#ifdef CONFIG_SND_AC97_POWER_SAVE
+	/* do cold reset - the full ac97 powerdown may leave the controller
+	 * in a warm state but actually it cannot communicate with the codec.
+	 */
+	iputdword(chip, ICHREG(GLOB_CNT), cnt & ~ICH_AC97COLD);
+	cnt = igetdword(chip, ICHREG(GLOB_CNT));
+	udelay(10);
+	iputdword(chip, ICHREG(GLOB_CNT), cnt | ICH_AC97COLD);
+	msleep(1);
+#else
 	/* finish cold or do warm reset */
 	cnt |= (cnt & ICH_AC97COLD) == 0 ? ICH_AC97COLD : ICH_AC97WARM;
 	iputdword(chip, ICHREG(GLOB_CNT), cnt);
@@ -2265,6 +2281,7 @@ static int snd_intel8x0_ich_chip_init(struct intel8x0 *chip, int probing)
 	return -EIO;
 
       __ok:
+#endif
 	if (probing) {
 		/* wait for any codec ready status.
 		 * Once it becomes ready it should remain ready
@@ -2465,10 +2482,14 @@ static int intel8x0_suspend(struct pci_dev *pci, pm_message_t state)
 	if (chip->device_type == DEVICE_INTEL_ICH4)
 		chip->sdm_saved = igetbyte(chip, ICHREG(SDM));
 
-	if (chip->irq >= 0)
+	if (chip->irq >= 0) {
+		synchronize_irq(chip->irq);
 		free_irq(chip->irq, chip);
+		chip->irq = -1;
+	}
 	pci_disable_device(pci);
 	pci_save_state(pci);
+	pci_set_power_state(pci, pci_choose_state(pci, state));
 	return 0;
 }
 
@@ -2478,14 +2499,25 @@ static int intel8x0_resume(struct pci_dev *pci)
 	struct intel8x0 *chip = card->private_data;
 	int i;
 
+	pci_set_power_state(pci, PCI_D0);
 	pci_restore_state(pci);
-	pci_enable_device(pci);
+	if (pci_enable_device(pci) < 0) {
+		printk(KERN_ERR "intel8x0: pci_enable_device failed, "
+		       "disabling device\n");
+		snd_card_disconnect(card);
+		return -EIO;
+	}
 	pci_set_master(pci);
-	request_irq(pci->irq, snd_intel8x0_interrupt, IRQF_DISABLED|IRQF_SHARED,
-		    card->shortname, chip);
+	if (request_irq(pci->irq, snd_intel8x0_interrupt,
+			IRQF_DISABLED|IRQF_SHARED, card->shortname, chip)) {
+		printk(KERN_ERR "intel8x0: unable to grab IRQ %d, "
+		       "disabling device\n", pci->irq);
+		snd_card_disconnect(card);
+		return -EIO;
+	}
 	chip->irq = pci->irq;
 	synchronize_irq(chip->irq);
-	snd_intel8x0_chip_init(chip, 1);
+	snd_intel8x0_chip_init(chip, 0);
 
 	/* re-initialize mixer stuff */
 	if (chip->device_type == DEVICE_INTEL_ICH4) {
@@ -2615,6 +2647,7 @@ static void __devinit intel8x0_measure_ac97_clock(struct intel8x0 *chip)
 		/* not 48000Hz, tuning the clock.. */
 		chip->ac97_bus->clock = (chip->ac97_bus->clock * 48000) / pos;
 	printk(KERN_INFO "intel8x0: clocking to %d\n", chip->ac97_bus->clock);
+	snd_ac97_update_power(chip->ac97[0], AC97_PCM_FRONT_DAC_RATE, 0);
 }
 
 #ifdef CONFIG_PROC_FS