+/*
+ * spi_gpio.c - SPI master driver using generic bitbanged GPIO
+ *
+ * Copyright (C) 2006,2008 David Brownell
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
+ */
+#include <linux/kernel.h>
+#include <linux/init.h>
+#include <linux/platform_device.h>
+#include <linux/gpio.h>
+
+#include <linux/spi/spi.h>
+#include <linux/spi/spi_bitbang.h>
+#include <linux/spi/spi_gpio.h>
+
+
+/*
+ * This bitbanging SPI master driver should help make systems usable
+ * when a native hardware SPI engine is not available, perhaps because
+ * its driver isn't yet working or because the I/O pins it requires
+ * are used for other purposes.
+ *
+ * platform_device->driver_data ... points to spi_gpio
+ *
+ * spi->controller_state ... reserved for bitbang framework code
+ * spi->controller_data ... holds chipselect GPIO
+ *
+ * spi->master->dev.driver_data ... points to spi_gpio->bitbang
+ */
+
+struct spi_gpio {
+ struct spi_bitbang bitbang;
+ struct spi_gpio_platform_data pdata;
+ struct platform_device *pdev;
+};
+
+/*----------------------------------------------------------------------*/
+
+/*
+ * Because the overhead of going through four GPIO procedure calls
+ * per transferred bit can make performance a problem, this code
+ * is set up so that you can use it in either of two ways:
+ *
+ * - The slow generic way: set up platform_data to hold the GPIO
+ * numbers used for MISO/MOSI/SCK, and issue procedure calls for
+ * each of them. This driver can handle several such busses.
+ *
+ * - The quicker inlined way: only helps with platform GPIO code
+ * that inlines operations for constant GPIOs. This can give
+ * you tight (fast!) inner loops, but each such bus needs a
+ * new driver. You'll define a new C file, with Makefile and
+ * Kconfig support; the C code can be a total of six lines:
+ *
+ * #define DRIVER_NAME "myboard_spi2"
+ * #define SPI_MISO_GPIO 119
+ * #define SPI_MOSI_GPIO 120
+ * #define SPI_SCK_GPIO 121
+ * #define SPI_N_CHIPSEL 4
+ * #include "spi_gpio.c"
+ */
+
+#ifndef DRIVER_NAME
+#define DRIVER_NAME "spi_gpio"
+
+#define GENERIC_BITBANG /* vs tight inlines */
+
+/* all functions referencing these symbols must define pdata */
+#define SPI_MISO_GPIO ((pdata)->miso)
+#define SPI_MOSI_GPIO ((pdata)->mosi)
+#define SPI_SCK_GPIO ((pdata)->sck)
+
+#define SPI_N_CHIPSEL ((pdata)->num_chipselect)
+
+#endif
+
+/*----------------------------------------------------------------------*/
+
+static inline const struct spi_gpio_platform_data * __pure
+spi_to_pdata(const struct spi_device *spi)
+{
+ const struct spi_bitbang *bang;
+ const struct spi_gpio *spi_gpio;
+
+ bang = spi_master_get_devdata(spi->master);
+ spi_gpio = container_of(bang, struct spi_gpio, bitbang);
+ return &spi_gpio->pdata;
+}
+
+/* this is #defined to avoid unused-variable warnings when inlining */
+#define pdata spi_to_pdata(spi)
+
+static inline void setsck(const struct spi_device *spi, int is_on)
+{
+ gpio_set_value(SPI_SCK_GPIO, is_on);
+}
+
+static inline void setmosi(const struct spi_device *spi, int is_on)
+{
+ gpio_set_value(SPI_MOSI_GPIO, is_on);
+}
+
+static inline int getmiso(const struct spi_device *spi)
+{
+ return gpio_get_value(SPI_MISO_GPIO);
+}
+
+#undef pdata
+
+/*
+ * NOTE: this clocks "as fast as we can". It "should" be a function of the
+ * requested device clock. Software overhead means we usually have trouble
+ * reaching even one Mbit/sec (except when we can inline bitops), so for now
+ * we'll just assume we never need additional per-bit slowdowns.
+ */
+#define spidelay(nsecs) do {} while (0)
+
+#define EXPAND_BITBANG_TXRX
+#include <linux/spi/spi_bitbang.h>
+
+/*
+ * These functions can leverage inline expansion of GPIO calls to shrink
+ * costs for a txrx bit, often by factors of around ten (by instruction
+ * count). That is particularly visible for larger word sizes, but helps
+ * even with default 8-bit words.
+ *
+ * REVISIT overheads calling these functions for each word also have
+ * significant performance costs. Having txrx_bufs() calls that inline
+ * the txrx_word() logic would help performance, e.g. on larger blocks
+ * used with flash storage or MMC/SD. There should also be ways to make
+ * GCC be less stupid about reloading registers inside the I/O loops,
+ * even without inlined GPIO calls; __attribute__((hot)) on GCC 4.3?
+ */
+
+static u32 spi_gpio_txrx_word_mode0(struct spi_device *spi,
+ unsigned nsecs, u32 word, u8 bits)
+{
+ return bitbang_txrx_be_cpha0(spi, nsecs, 0, word, bits);
+}
+
+static u32 spi_gpio_txrx_word_mode1(struct spi_device *spi,
+ unsigned nsecs, u32 word, u8 bits)
+{
+ return bitbang_txrx_be_cpha1(spi, nsecs, 0, word, bits);
+}
+
+static u32 spi_gpio_txrx_word_mode2(struct spi_device *spi,
+ unsigned nsecs, u32 word, u8 bits)
+{
+ return bitbang_txrx_be_cpha0(spi, nsecs, 1, word, bits);
+}
+
+static u32 spi_gpio_txrx_word_mode3(struct spi_device *spi,
+ unsigned nsecs, u32 word, u8 bits)
+{
+ return bitbang_txrx_be_cpha1(spi, nsecs, 1, word, bits);
+}
+
+/*----------------------------------------------------------------------*/
+
+static void spi_gpio_chipselect(struct spi_device *spi, int is_active)
+{
+ unsigned long cs = (unsigned long) spi->controller_data;
+
+ /* set initial clock polarity */
+ if (is_active)
+ setsck(spi, spi->mode & SPI_CPOL);
+
+ /* SPI is normally active-low */
+ gpio_set_value(cs, (spi->mode & SPI_CS_HIGH) ? is_active : !is_active);
+}
+
+static int spi_gpio_setup(struct spi_device *spi)
+{
+ unsigned long cs = (unsigned long) spi->controller_data;
+ int status = 0;
+
+ if (spi->bits_per_word > 32)
+ return -EINVAL;
+
+ if (!spi->controller_state) {
+ status = gpio_request(cs, spi->dev.bus_id);
+ if (status)
+ return status;
+ status = gpio_direction_output(cs, spi->mode & SPI_CS_HIGH);
+ }
+ if (!status)
+ status = spi_bitbang_setup(spi);
+ if (status) {
+ if (!spi->controller_state)
+ gpio_free(cs);
+ }
+ return status;
+}
+
+static void spi_gpio_cleanup(struct spi_device *spi)
+{
+ unsigned long cs = (unsigned long) spi->controller_data;
+
+ gpio_free(cs);
+ spi_bitbang_cleanup(spi);
+}
+
+static int __init spi_gpio_alloc(unsigned pin, const char *label, bool is_in)
+{
+ int value;
+
+ value = gpio_request(pin, label);
+ if (value == 0) {
+ if (is_in)
+ value = gpio_direction_input(pin);
+ else
+ value = gpio_direction_output(pin, 0);
+ }
+ return value;
+}
+
+static int __init
+spi_gpio_request(struct spi_gpio_platform_data *pdata, const char *label)
+{
+ int value;
+
+ /* NOTE: SPI_*_GPIO symbols may reference "pdata" */
+
+ value = spi_gpio_alloc(SPI_MOSI_GPIO, label, false);
+ if (value)
+ goto done;
+
+ value = spi_gpio_alloc(SPI_MISO_GPIO, label, true);
+ if (value)
+ goto free_mosi;
+
+ value = spi_gpio_alloc(SPI_SCK_GPIO, label, false);
+ if (value)
+ goto free_miso;
+
+ goto done;
+
+free_miso:
+ gpio_free(SPI_MISO_GPIO);
+free_mosi:
+ gpio_free(SPI_MOSI_GPIO);
+done:
+ return value;
+}
+
+static int __init spi_gpio_probe(struct platform_device *pdev)
+{
+ int status;
+ struct spi_master *master;
+ struct spi_gpio *spi_gpio;
+ struct spi_gpio_platform_data *pdata;
+
+ pdata = pdev->dev.platform_data;
+#ifdef GENERIC_BITBANG
+ if (!pdata || !pdata->num_chipselect)
+ return -ENODEV;
+#endif
+
+ status = spi_gpio_request(pdata, dev_name(&pdev->dev));
+ if (status < 0)
+ return status;
+
+ master = spi_alloc_master(&pdev->dev, sizeof *spi_gpio);
+ if (!master) {
+ status = -ENOMEM;
+ goto gpio_free;
+ }
+ spi_gpio = spi_master_get_devdata(master);
+ platform_set_drvdata(pdev, spi_gpio);
+
+ spi_gpio->pdev = pdev;
+ if (pdata)
+ spi_gpio->pdata = *pdata;
+
+ master->bus_num = pdev->id;
+ master->num_chipselect = SPI_N_CHIPSEL;
+ master->setup = spi_gpio_setup;
+ master->cleanup = spi_gpio_cleanup;
+
+ spi_gpio->bitbang.master = spi_master_get(master);
+ spi_gpio->bitbang.chipselect = spi_gpio_chipselect;
+ spi_gpio->bitbang.txrx_word[SPI_MODE_0] = spi_gpio_txrx_word_mode0;
+ spi_gpio->bitbang.txrx_word[SPI_MODE_1] = spi_gpio_txrx_word_mode1;
+ spi_gpio->bitbang.txrx_word[SPI_MODE_2] = spi_gpio_txrx_word_mode2;
+ spi_gpio->bitbang.txrx_word[SPI_MODE_3] = spi_gpio_txrx_word_mode3;
+ spi_gpio->bitbang.setup_transfer = spi_bitbang_setup_transfer;
+ spi_gpio->bitbang.flags = SPI_CS_HIGH;
+
+ status = spi_bitbang_start(&spi_gpio->bitbang);
+ if (status < 0) {
+ spi_master_put(spi_gpio->bitbang.master);
+gpio_free:
+ gpio_free(SPI_MISO_GPIO);
+ gpio_free(SPI_MOSI_GPIO);
+ gpio_free(SPI_SCK_GPIO);
+ spi_master_put(master);
+ }
+
+ return status;
+}
+
+static int __exit spi_gpio_remove(struct platform_device *pdev)
+{
+ struct spi_gpio *spi_gpio;
+ struct spi_gpio_platform_data *pdata;
+ int status;
+
+ spi_gpio = platform_get_drvdata(pdev);
+ pdata = pdev->dev.platform_data;
+
+ /* stop() unregisters child devices too */
+ status = spi_bitbang_stop(&spi_gpio->bitbang);
+ spi_master_put(spi_gpio->bitbang.master);
+
+ platform_set_drvdata(pdev, NULL);
+
+ gpio_free(SPI_MISO_GPIO);
+ gpio_free(SPI_MOSI_GPIO);
+ gpio_free(SPI_SCK_GPIO);
+
+ return status;
+}
+
+MODULE_ALIAS("platform:" DRIVER_NAME);
+
+static struct platform_driver spi_gpio_driver = {
+ .driver.name = DRIVER_NAME,
+ .driver.owner = THIS_MODULE,
+ .remove = __exit_p(spi_gpio_remove),
+};
+
+static int __init spi_gpio_init(void)
+{
+ return platform_driver_probe(&spi_gpio_driver, spi_gpio_probe);
+}
+module_init(spi_gpio_init);
+
+static void __exit spi_gpio_exit(void)
+{
+ platform_driver_unregister(&spi_gpio_driver);
+}
+module_exit(spi_gpio_exit);
+
+
+MODULE_DESCRIPTION("SPI master driver using generic bitbanged GPIO ");
+MODULE_AUTHOR("David Brownell");
+MODULE_LICENSE("GPL");
projects / linux-2.6-omap-h63xx.git / commitdiff