Change INT0 trigger mode from edge-sense mode to level-sense mode,
in order to fix the following timeout error:
  'NETDEV WATCHDOG: eth0: transmit timed out'.
This patch is required only for the Mappi platform.
Signed-off-by: Hirokazu Takata <takata@linux-m32r.org>
Cc: Hitoshi Yamamoto <hitoshiy@linux-m32r.org>
Cc: Jeff Garzik <jeff@garzik.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
 
 static void end_mappi_irq(unsigned int irq)
 {
-       enable_mappi_irq(irq);
+       if (!(irq_desc[irq].status & (IRQ_DISABLED | IRQ_INPROGRESS)))
+               enable_mappi_irq(irq);
 }
 
 static unsigned int startup_mappi_irq(unsigned int irq)
        irq_desc[M32R_IRQ_INT0].chip = &mappi_irq_type;
        irq_desc[M32R_IRQ_INT0].action = NULL;
        irq_desc[M32R_IRQ_INT0].depth = 1;
-       icu_data[M32R_IRQ_INT0].icucr = M32R_ICUCR_IEN|M32R_ICUCR_ISMOD10;
+       icu_data[M32R_IRQ_INT0].icucr = M32R_ICUCR_IEN|M32R_ICUCR_ISMOD11;
        disable_mappi_irq(M32R_IRQ_INT0);
 #endif /* CONFIG_M32R_NE2000 */
 
 
        int txsr, isr, tickssofar = jiffies - dev->trans_start;
        unsigned long flags;
 
-#if defined(CONFIG_M32R) && defined(CONFIG_SMP)
-       unsigned long icucr;
-
-       local_irq_save(flags);
-       icucr = inl(M32R_ICU_CR1_PORTL);
-       icucr |= M32R_ICUCR_ISMOD11;
-       outl(icucr, M32R_ICU_CR1_PORTL);
-       local_irq_restore(flags);
-#endif
        ei_local->stat.tx_errors++;
 
        spin_lock_irqsave(&ei_local->page_lock, flags);