]> pilppa.org Git - linux-2.6-omap-h63xx.git/commitdiff
Blackfin Serial Driver: the uart break anomaly has been given its own number, so...
authorMike Frysinger <vapier.adi@gmail.com>
Thu, 24 Apr 2008 19:03:03 +0000 (03:03 +0800)
committerBryan Wu <cooloney@kernel.org>
Thu, 24 Apr 2008 19:03:03 +0000 (03:03 +0800)
Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
drivers/serial/bfin_5xx.c

index 8dab6644297c39a9992d7d61505d0213d34edde1..47ca7b0267df26338423183a24f3d63feff136ae 100644 (file)
@@ -194,7 +194,7 @@ int kgdb_get_debug_char(void)
 }
 #endif
 
-#if ANOMALY_05000230 && defined(CONFIG_SERIAL_BFIN_PIO)
+#if ANOMALY_05000363 && defined(CONFIG_SERIAL_BFIN_PIO)
 # define UART_GET_ANOMALY_THRESHOLD(uart)    ((uart)->anomaly_threshold)
 # define UART_SET_ANOMALY_THRESHOLD(uart, v) ((uart)->anomaly_threshold = (v))
 #else
@@ -239,7 +239,7 @@ static void bfin_serial_rx_chars(struct bfin_serial_port *uart)
        }
 #endif
 
-       if (ANOMALY_05000230) {
+       if (ANOMALY_05000363) {
                /* The BF533 (and BF561) family of processors have a nice anomaly
                 * where they continuously generate characters for a "single" break.
                 * We have to basically ignore this flood until the "next" valid
@@ -251,9 +251,6 @@ static void bfin_serial_rx_chars(struct bfin_serial_port *uart)
                 * timeout was picked as it must absolutely be larger than 1
                 * character time +/- some percent.  So 1.5 sounds good.  All other
                 * Blackfin families operate properly.  Woo.
-                * Note: While Anomaly 05000230 does not directly address this,
-                *       the changes that went in for it also fixed this issue.
-                *       That anomaly was fixed in 0.5+ silicon.  I like bunnies.
                 */
                if (anomaly_start.tv_sec) {
                        struct timeval curr;
@@ -287,7 +284,7 @@ static void bfin_serial_rx_chars(struct bfin_serial_port *uart)
        }
 
        if (status & BI) {
-               if (ANOMALY_05000230)
+               if (ANOMALY_05000363)
                        if (bfin_revid() < 5)
                                do_gettimeofday(&anomaly_start);
                uart->port.icount.brk++;