.proc_handler   = &ftrace_enable_sysctl,
        },
 #endif
+#ifdef CONFIG_TRACING
+       {
+               .ctl_name       = CTL_UNNUMBERED,
+               .procname       = "ftrace_dump_on_opps",
+               .data           = &ftrace_dump_on_oops,
+               .maxlen         = sizeof(int),
+               .mode           = 0644,
+               .proc_handler   = &proc_dointvec,
+       },
+#endif
 #ifdef CONFIG_MODULES
        {
                .ctl_name       = KERN_MODPROBE,
 
 
 static int tracing_disabled = 1;
 
+/*
+ * ftrace_dump_on_oops - variable to dump ftrace buffer on oops
+ *
+ * If there is an oops (or kernel panic) and the ftrace_dump_on_oops
+ * is set, then ftrace_dump is called. This will output the contents
+ * of the ftrace buffers to the console.  This is very useful for
+ * capturing traces that lead to crashes and outputing it to a
+ * serial console.
+ *
+ * It is default off, but you can enable it with either specifying
+ * "ftrace_dump_on_oops" in the kernel command line, or setting
+ * /proc/sys/kernel/ftrace_dump_on_oops to true.
+ */
+int ftrace_dump_on_oops;
+
+static int __init set_ftrace_dump_on_oops(char *str)
+{
+       ftrace_dump_on_oops = 1;
+       return 1;
+}
+__setup("ftrace_dump_on_oops", set_ftrace_dump_on_oops);
+
 long
 ns2usecs(cycle_t nsec)
 {
 static int trace_panic_handler(struct notifier_block *this,
                               unsigned long event, void *unused)
 {
-       ftrace_dump();
+       if (ftrace_dump_on_oops)
+               ftrace_dump();
        return NOTIFY_OK;
 }
 
 {
        switch (val) {
        case DIE_OOPS:
-               ftrace_dump();
+               if (ftrace_dump_on_oops)
+                       ftrace_dump();
                break;
        default:
                break;
        trace_seq_reset(s);
 }
 
-
 void ftrace_dump(void)
 {
        static DEFINE_SPINLOCK(ftrace_dump_lock);