IB/ipath: Add the work completion error code to the QP error debug output

Add the work completion error code to the QP error debug output.
This makes it easier to determine the cause of the error.

Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>

diff --git a/drivers/infiniband/hw/ipath/ipath_qp.c b/drivers/infiniband/hw/ipath/ipath_qp.c
index b997ff88401bf5f3ceca581a48ac05d4a94ba079..b405906974ca4a3381637fbacacffc7f675fbe53 100644 (file)
--- a/drivers/infiniband/hw/ipath/ipath_qp.c
+++ b/drivers/infiniband/hw/ipath/ipath_qp.c
@@ -387,8 +387,8 @@ int ipath_error_qp(struct ipath_qp *qp, enum ib_wc_status err)
        struct ib_wc wc;
        int ret = 0;
 
-       ipath_dbg("QP%d/%d in error state\n",
-                 qp->ibqp.qp_num, qp->remote_qpn);
+       ipath_dbg("QP%d/%d in error state (%d)\n",
+                 qp->ibqp.qp_num, qp->remote_qpn, err);
 
        spin_lock(&dev->pending_lock);
        /* XXX What if its already removed by the timeout code? */