CONFIG_PLAT_S3C24XX=y
 CONFIG_CPU_S3C244X=y
 CONFIG_PM_SIMTEC=y
-# CONFIG_S3C2410_BOOT_WATCHDOG is not set
-# CONFIG_S3C2410_BOOT_ERROR_RESET is not set
+# CONFIG_S3C_BOOT_WATCHDOG is not set
+# CONFIG_S3C_BOOT_ERROR_RESET is not set
 # CONFIG_S3C2410_PM_DEBUG is not set
 # CONFIG_S3C2410_PM_CHECK is not set
 CONFIG_S3C_LOWLEVEL_UART_PORT=0
 
 
 comment "Boot options"
 
-config S3C2410_BOOT_WATCHDOG
-       bool "S3C2410 Initialisation watchdog"
+config S3C_BOOT_WATCHDOG
+       bool "S3C Initialisation watchdog"
        depends on PLAT_S3C && S3C2410_WATCHDOG
        help
          Say y to enable the watchdog during the kernel decompression
          stage. If the kernel fails to uncompress, then the watchdog
          will trigger a reset and the system should restart.
 
-config S3C2410_BOOT_ERROR_RESET
-       bool "S3C2410 Reboot on decompression error"
+config S3C_BOOT_ERROR_RESET
+       bool "S3C Reboot on decompression error"
        depends on PLAT_S3C
        help
          Say y here to use the watchdog to reset the system if the
 
 
 #define __raw_writel(d,ad) do { *((volatile unsigned int *)(ad)) = (d); } while(0)
 
-/* CONFIG_S3C2410_BOOT_WATCHDOG
+/* CONFIG_S3C_BOOT_WATCHDOG
  *
  * Simple boot-time watchdog setup, to reboot the system if there is
  * any problem with the boot process
 */
 
-#ifdef CONFIG_S3C2410_BOOT_WATCHDOG
+#ifdef CONFIG_S3C_BOOT_WATCHDOG
 
 #define WDOG_COUNT (0xff00)
 
 #define arch_decomp_wdog()
 #endif
 
-#ifdef CONFIG_S3C2410_BOOT_ERROR_RESET
+#ifdef CONFIG_S3C_BOOT_ERROR_RESET
 
 static void arch_decomp_error(const char *x)
 {