.resource       = sa1111_resources,
 };
 
-static struct resource smc91x_resources[] = {
-       [0] = {
-               .name   = "smc91x-regs",
-               .start  = 0x0c000c00,
-               .end    = 0x0c0fffff,
-               .flags  = IORESOURCE_MEM,
-       },
-       [1] = {
-               .start  = LUBBOCK_ETH_IRQ,
-               .end    = LUBBOCK_ETH_IRQ,
-               .flags  = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHEDGE,
-       },
-       [2] = {
-               .name   = "smc91x-attrib",
-               .start  = 0x0e000000,
-               .end    = 0x0e0fffff,
-               .flags  = IORESOURCE_MEM,
-       },
-};
-
 /* ADS7846 is connected through SSP ... and if your board has J5 populated,
  * you can select it to replace the ucb1400 by switching the touchscreen cable
  * (to J5) and poking board registers (as done below).  Else it's only useful
 },
 };
 
+static struct resource smc91x_resources[] = {
+       [0] = {
+               .name   = "smc91x-regs",
+               .start  = 0x0c000c00,
+               .end    = 0x0c0fffff,
+               .flags  = IORESOURCE_MEM,
+       },
+       [1] = {
+               .start  = LUBBOCK_ETH_IRQ,
+               .end    = LUBBOCK_ETH_IRQ,
+               .flags  = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHEDGE,
+       },
+       [2] = {
+               .name   = "smc91x-attrib",
+               .start  = 0x0e000000,
+               .end    = 0x0e0fffff,
+               .flags  = IORESOURCE_MEM,
+       },
+};
+
 static struct platform_device smc91x_device = {
        .name           = "smc91x",
        .id             = -1,