Remove CONFIG_ACPI_POWER.  It was always set the same as CONFIG_ACPI,
and it had no menu label, so there was no way to set it to anything
other than "y".
The interfaces under CONFIG_ACPI_POWER (acpi_device_sleep_wake(),
acpi_power_transition(), etc) are called unconditionally from the
ACPI core, so we already depend on it always being present.
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Len Brown <len.brown@intel.com>
          help you correlate PCI bus addresses with the physical geography
          of your slots. If you are unsure, say N.
 
-config ACPI_POWER
-       bool
-       default y
-
 config ACPI_SYSTEM
        bool
        default y
 
 obj-$(CONFIG_ACPI_PROCESSOR)   += processor.o
 obj-$(CONFIG_ACPI_CONTAINER)   += container.o
 obj-$(CONFIG_ACPI_THERMAL)     += thermal.o
-obj-$(CONFIG_ACPI_POWER)       += power.o
+obj-y                          += power.o
 obj-$(CONFIG_ACPI_SYSTEM)      += system.o event.o
 obj-$(CONFIG_ACPI_DEBUG)       += debug.o
 obj-$(CONFIG_ACPI_NUMA)                += numa.o
 
                                   Power Resource
    -------------------------------------------------------------------------- */
 
-#ifdef CONFIG_ACPI_POWER
 int acpi_device_sleep_wake(struct acpi_device *dev,
                            int enable, int sleep_state, int dev_state);
 int acpi_enable_wakeup_device_power(struct acpi_device *dev, int sleep_state);
 int acpi_power_get_inferred_state(struct acpi_device *device);
 int acpi_power_transition(struct acpi_device *device, int state);
 extern int acpi_power_nocheck;
-#endif
 
 /* --------------------------------------------------------------------------
                                   Embedded Controller