2 * Definitions for using the Apple Descriptor-Based DMA controller
3 * in Power Macintosh computers.
5 * Copyright (C) 1996 Paul Mackerras.
12 * DBDMA control/status registers. All little-endian.
15 unsigned int control; /* lets you change bits in status */
16 unsigned int status; /* DMA and device status bits (see below) */
17 unsigned int cmdptr_hi; /* upper 32 bits of command address */
18 unsigned int cmdptr; /* (lower 32 bits of) command address (phys) */
19 unsigned int intr_sel; /* select interrupt condition bit */
20 unsigned int br_sel; /* select branch condition bit */
21 unsigned int wait_sel; /* select wait condition bit */
22 unsigned int xfer_mode;
23 unsigned int data2ptr_hi;
24 unsigned int data2ptr;
26 unsigned int address_hi;
27 unsigned int br_addr_hi;
31 /* Bits in control and status registers */
39 #define DEVSTAT 0x00ff
42 * DBDMA command structure. These fields are all little-endian!
45 unsigned short req_count; /* requested byte transfer count */
46 unsigned short command; /* command word (has bit-fields) */
47 unsigned int phy_addr; /* physical data address */
48 unsigned int cmd_dep; /* command-dependent field */
49 unsigned short res_count; /* residual count after completion */
50 unsigned short xfer_status; /* transfer status */
53 /* DBDMA command values in command field */
54 #define OUTPUT_MORE 0 /* transfer memory data to stream */
55 #define OUTPUT_LAST 0x1000 /* ditto followed by end marker */
56 #define INPUT_MORE 0x2000 /* transfer stream data to memory */
57 #define INPUT_LAST 0x3000 /* ditto, expect end marker */
58 #define STORE_WORD 0x4000 /* write word (4 bytes) to device reg */
59 #define LOAD_WORD 0x5000 /* read word (4 bytes) from device reg */
60 #define DBDMA_NOP 0x6000 /* do nothing */
61 #define DBDMA_STOP 0x7000 /* suspend processing */
63 /* Key values in command field */
64 #define KEY_STREAM0 0 /* usual data stream */
65 #define KEY_STREAM1 0x100 /* control/status stream */
66 #define KEY_STREAM2 0x200 /* device-dependent stream */
67 #define KEY_STREAM3 0x300 /* device-dependent stream */
68 #define KEY_REGS 0x500 /* device register space */
69 #define KEY_SYSTEM 0x600 /* system memory-mapped space */
70 #define KEY_DEVICE 0x700 /* device memory-mapped space */
72 /* Interrupt control values in command field */
73 #define INTR_NEVER 0 /* don't interrupt */
74 #define INTR_IFSET 0x10 /* intr if condition bit is 1 */
75 #define INTR_IFCLR 0x20 /* intr if condition bit is 0 */
76 #define INTR_ALWAYS 0x30 /* always interrupt */
78 /* Branch control values in command field */
79 #define BR_NEVER 0 /* don't branch */
80 #define BR_IFSET 0x4 /* branch if condition bit is 1 */
81 #define BR_IFCLR 0x8 /* branch if condition bit is 0 */
82 #define BR_ALWAYS 0xc /* always branch */
84 /* Wait control values in command field */
85 #define WAIT_NEVER 0 /* don't wait */
86 #define WAIT_IFSET 1 /* wait if condition bit is 1 */
87 #define WAIT_IFCLR 2 /* wait if condition bit is 0 */
88 #define WAIT_ALWAYS 3 /* always wait */
90 /* Align an address for a DBDMA command structure */
91 #define DBDMA_ALIGN(x) (((unsigned long)(x) + sizeof(struct dbdma_cmd) - 1) \
92 & -sizeof(struct dbdma_cmd))
95 #define DBDMA_DO_STOP(regs) do { \
96 out_le32(&((regs)->control), (RUN|FLUSH)<<16); \
97 while(in_le32(&((regs)->status)) & (ACTIVE|FLUSH)) \
101 #define DBDMA_DO_RESET(regs) do { \
102 out_le32(&((regs)->control), (ACTIVE|DEAD|WAKE|FLUSH|PAUSE|RUN)<<16);\
103 while(in_le32(&((regs)->status)) & (RUN)) \
107 #endif /* _ASM_DBDMA_H_ */
108 #endif /* __KERNEL__ */