2 # Touchscreen driver configuration
4 menuconfig INPUT_TOUCHSCREEN
7 Say Y here, and a list of supported touchscreens will be displayed.
8 This option doesn't affect the kernel.
14 config TOUCHSCREEN_ADS7846
15 tristate "ADS7846/TSC2046 and ADS7843 based touchscreens"
17 depends on HWMON = n || HWMON
19 Say Y here if you have a touchscreen interface using the
20 ADS7846/TSC2046 or ADS7843 controller, and your board-specific
21 setup code includes that in its table of SPI devices.
23 If HWMON is selected, and the driver is told the reference voltage
24 on your board, you will also get hwmon interfaces for the voltage
25 (and on ads7846/tsc2046, temperature) sensors of this chip.
27 If unsure, say N (but it's safe to say "Y").
29 To compile this driver as a module, choose M here: the
30 module will be called ads7846.
32 config TOUCHSCREEN_BITSY
33 tristate "Compaq iPAQ H3600 (Bitsy) touchscreen"
34 depends on SA1100_BITSY
37 Say Y here if you have the h3600 (Bitsy) touchscreen.
41 To compile this driver as a module, choose M here: the
42 module will be called h3600_ts_input.
44 config TOUCHSCREEN_CORGI
45 tristate "SharpSL (Corgi and Spitz series) touchscreen driver"
46 depends on PXA_SHARPSL
49 Say Y here to enable the driver for the touchscreen on the
50 Sharp SL-C7xx and SL-Cxx00 series of PDAs.
54 To compile this driver as a module, choose M here: the
55 module will be called corgi_ts.
57 config TOUCHSCREEN_FUJITSU
58 tristate "Fujitsu serial touchscreen"
61 Say Y here if you have the Fujitsu touchscreen (such as one
62 installed in Lifebook P series laptop) connected to your
67 To compile this driver as a module, choose M here: the
68 module will be called fujitsu-ts.
70 config TOUCHSCREEN_GUNZE
71 tristate "Gunze AHL-51S touchscreen"
74 Say Y here if you have the Gunze AHL-51 touchscreen connected to
79 To compile this driver as a module, choose M here: the
80 module will be called gunze.
82 config TOUCHSCREEN_ELO
83 tristate "Elo serial touchscreens"
86 Say Y here if you have an Elo serial touchscreen connected to
91 To compile this driver as a module, choose M here: the
92 module will be called elo.
94 config TOUCHSCREEN_MTOUCH
95 tristate "MicroTouch serial touchscreens"
98 Say Y here if you have a MicroTouch (3M) serial touchscreen connected to
103 To compile this driver as a module, choose M here: the
104 module will be called mtouch.
106 config TOUCHSCREEN_MK712
107 tristate "ICS MicroClock MK712 touchscreen"
109 Say Y here if you have the ICS MicroClock MK712 touchscreen
110 controller chip in your system.
114 To compile this driver as a module, choose M here: the
115 module will be called mk712.
117 config TOUCHSCREEN_HP600
118 tristate "HP Jornada 680/690 touchscreen"
119 depends on SH_HP6XX && SH_ADC
121 Say Y here if you have a HP Jornada 680 or 690 and want to
122 support the built-in touchscreen.
126 To compile this driver as a module, choose M here: the
127 module will be called hp680_ts_input.
129 config TOUCHSCREEN_PENMOUNT
130 tristate "Penmount serial touchscreen"
133 Say Y here if you have a Penmount serial touchscreen connected to
138 To compile this driver as a module, choose M here: the
139 module will be called penmount.
141 config TOUCHSCREEN_TOUCHRIGHT
142 tristate "Touchright serial touchscreen"
145 Say Y here if you have a Touchright serial touchscreen connected to
150 To compile this driver as a module, choose M here: the
151 module will be called touchright.
153 config TOUCHSCREEN_TOUCHWIN
154 tristate "Touchwin serial touchscreen"
157 Say Y here if you have a Touchwin serial touchscreen connected to
162 To compile this driver as a module, choose M here: the
163 module will be called touchwin.
165 config TOUCHSCREEN_UCB1400
166 tristate "Philips UCB1400 touchscreen"
169 This enables support for the Philips UCB1400 touchscreen interface.
170 The UCB1400 is an AC97 audio codec. The touchscreen interface
171 will be initialized only after the ALSA subsystem has been
172 brought up and the UCB1400 detected. You therefore have to
173 configure ALSA support as well (either built-in or modular,
174 independently of whether this driver is itself built-in or
175 modular) for this driver to work.
177 To compile this driver as a module, choose M here: the
178 module will be called ucb1400_ts.
180 config TOUCHSCREEN_TSC2102
181 tristate "TSC 2102 based touchscreens"
182 depends on SPI_MASTER
185 Say Y here if you have a touchscreen interface using the
186 TI TSC 2102 controller, and your board-specific initialization
187 code includes that in its table of SPI devices. Also make
188 sure the proper SPI controller is selected.
190 If unsure, say N (but it's safe to say "Y").
192 To compile this driver as a module, choose M here: the
193 module will be called tsc2102_ts.
195 config TOUCHSCREEN_TSC2301
196 tristate "TSC2301 touchscreen support"
197 depends on SPI_TSC2301
199 Say Y here for if you are using the touchscreen features of TSC2301.
201 config TOUCHSCREEN_USB_COMPOSITE
202 tristate "USB Touchscreen Driver"
203 depends on USB_ARCH_HAS_HCD
206 USB Touchscreen driver for:
207 - eGalax Touchkit USB (also includes eTurboTouch CT-410/510/700)
208 - PanJit TouchSet USB
209 - 3M MicroTouch USB (EX II series)
211 - some other eTurboTouch
214 - IRTOUCHSYSTEMS/UNITOP
216 Have a look at <http://linux.chapter7.ch/touchkit/> for
217 a usage description and the required user-space stuff.
219 To compile this driver as a module, choose M here: the
220 module will be called usbtouchscreen.
222 config TOUCHSCREEN_USB_EGALAX
224 bool "eGalax, eTurboTouch CT-410/510/700 device support" if EMBEDDED
225 depends on TOUCHSCREEN_USB_COMPOSITE
227 config TOUCHSCREEN_USB_PANJIT
229 bool "PanJit device support" if EMBEDDED
230 depends on TOUCHSCREEN_USB_COMPOSITE
232 config TOUCHSCREEN_USB_3M
234 bool "3M/Microtouch EX II series device support" if EMBEDDED
235 depends on TOUCHSCREEN_USB_COMPOSITE
237 config TOUCHSCREEN_USB_ITM
239 bool "ITM device support" if EMBEDDED
240 depends on TOUCHSCREEN_USB_COMPOSITE
242 config TOUCHSCREEN_USB_ETURBO
244 bool "eTurboTouch (non-eGalax compatible) device support" if EMBEDDED
245 depends on TOUCHSCREEN_USB_COMPOSITE
247 config TOUCHSCREEN_USB_GUNZE
249 bool "Gunze AHL61 device support" if EMBEDDED
250 depends on TOUCHSCREEN_USB_COMPOSITE
252 config TOUCHSCREEN_USB_DMC_TSC10
254 bool "DMC TSC-10/25 device support" if EMBEDDED
255 depends on TOUCHSCREEN_USB_COMPOSITE
257 config TOUCHSCREEN_USB_IRTOUCH
259 bool "IRTOUCHSYSTEMS/UNITOP device support" if EMBEDDED
260 depends on TOUCHSCREEN_USB_COMPOSITE