Manually" section, below.
NOTE: It has been observed that some Red Hat supplied kernels
Manually" section, below.
NOTE: It has been observed that some Red Hat supplied kernels
part). Attempts to pass that option to modprobe will produce an
"Operation not permitted" error. This has been reported on some
Fedora Core kernels, and has been seen on RHEL 4 as well. On kernels
part). Attempts to pass that option to modprobe will produce an
"Operation not permitted" error. This has been reported on some
Fedora Core kernels, and has been seen on RHEL 4 as well. On kernels
This may be repeated any number of times, specifying a new and
unique name in place of bond1 for each subsequent instance.
This may be repeated any number of times, specifying a new and
unique name in place of bond1 for each subsequent instance.
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3573025 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643167 errors:1 dropped:0 overruns:1 carrier:0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3573025 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643167 errors:1 dropped:0 overruns:1 carrier:0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3651769 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643480 errors:0 dropped:0 overruns:0 carrier:0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3651769 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643480 errors:0 dropped:0 overruns:0 carrier:0
If running SNMP agents, the bonding driver should be loaded
before any network drivers participating in a bond. This requirement
If running SNMP agents, the bonding driver should be loaded
before any network drivers participating in a bond. This requirement
the first interface found with a given IP address. That is, there is
only one ipAdEntIfIndex for each IP address. For example, if eth0 and
eth1 are slaves of bond0 and the driver for eth0 is loaded before the
the first interface found with a given IP address. That is, there is
only one ipAdEntIfIndex for each IP address. For example, if eth0 and
eth1 are slaves of bond0 and the driver for eth0 is loaded before the
If not explicitly configured (with ifconfig or ip link), the
MAC address of the bonding device is taken from its first slave
device. This MAC address is then passed to all following slaves and
If not explicitly configured (with ifconfig or ip link), the
MAC address of the bonding device is taken from its first slave
device. This MAC address is then passed to all following slaves and
bonding device is brought down or reconfigured.
If you wish to change the MAC address, you can set it with
bonding device is brought down or reconfigured.
If you wish to change the MAC address, you can set it with