Blackfin arch: add missing IORESOURCE_MEM flags to UART3

[linux-2.6-omap-h63xx.git] / Documentation / powerpc / mpc52xx-device-tree-bindings.txt

diff --git a/Documentation/powerpc/mpc52xx-device-tree-bindings.txt b/Documentation/powerpc/mpc52xx-device-tree-bindings.txt
index cda7a7dffa6d6376fb0b0e83f4e096a9c448ffed..6f12f1c79c0c82f4a93ffde90da6b96bd62485f9 100644 (file)
--- a/Documentation/powerpc/mpc52xx-device-tree-bindings.txt
+++ b/Documentation/powerpc/mpc52xx-device-tree-bindings.txt
@@ -237,6 +237,17 @@ Each GPIO controller node should have the empty property gpio-controller and
 according to the bit numbers in the GPIO control registers. The second cell
 is for flags which is currently unsused.
 
 according to the bit numbers in the GPIO control registers. The second cell
 is for flags which is currently unsused.
 

+8) FEC nodes
+The FEC node can specify one of the following properties to configure
+the MII link:
+"fsl,7-wire-mode" - An empty property that specifies the link uses 7-wire
+                    mode instead of MII
+"current-speed"   - Specifies that the MII should be configured for a fixed
+                    speed.  This property should contain two cells.  The
+                    first cell specifies the speed in Mbps and the second
+                    should be '0' for half duplex and '1' for full duplex
+"phy-handle"      - Contains a phandle to an Ethernet PHY.
+

 IV - Extra Notes
 ================
 
 IV - Extra Notes
 ================