+ priv->regs_win = ioremap(regs.start, regs.end - regs.start + 1);
+
+ /* Probe the master port phy type */
+ ccsr = in_be32(priv->regs_win + RIO_CCSR);
+ port->phy_type = (ccsr & 1) ? RIO_PHY_SERIAL : RIO_PHY_PARALLEL;
+ dev_info(&dev->dev, "RapidIO PHY type: %s\n",
+ (port->phy_type == RIO_PHY_PARALLEL) ? "parallel" :
+ ((port->phy_type == RIO_PHY_SERIAL) ? "serial" :
+ "unknown"));
+ /* Checking the port training status */
+ if (in_be32((priv->regs_win + RIO_ESCSR)) & 1) {
+ dev_err(&dev->dev, "Port is not ready. "
+ "Try to restart connection...\n");
+ switch (port->phy_type) {
+ case RIO_PHY_SERIAL:
+ /* Disable ports */
+ out_be32(priv->regs_win + RIO_CCSR, 0);
+ /* Set 1x lane */
+ setbits32(priv->regs_win + RIO_CCSR, 0x02000000);
+ /* Enable ports */
+ setbits32(priv->regs_win + RIO_CCSR, 0x00600000);
+ break;
+ case RIO_PHY_PARALLEL:
+ /* Disable ports */
+ out_be32(priv->regs_win + RIO_CCSR, 0x22000000);
+ /* Enable ports */
+ out_be32(priv->regs_win + RIO_CCSR, 0x44000000);
+ break;
+ }
+ msleep(100);
+ if (in_be32((priv->regs_win + RIO_ESCSR)) & 1) {
+ dev_err(&dev->dev, "Port restart failed.\n");
+ rc = -ENOLINK;
+ goto err;
+ }
+ dev_info(&dev->dev, "Port restart success!\n");
+ }
+ fsl_rio_info(&dev->dev, ccsr);
+
+ port->sys_size = (in_be32((priv->regs_win + RIO_PEF_CAR))
+ & RIO_PEF_CTLS) >> 4;
+ dev_info(&dev->dev, "RapidIO Common Transport System size: %d\n",
+ port->sys_size ? 65536 : 256);
+
+ priv->atmu_regs = (struct rio_atmu_regs *)(priv->regs_win
+ + RIO_ATMU_REGS_OFFSET);
+ priv->maint_atmu_regs = priv->atmu_regs + 1;
+ priv->dbell_atmu_regs = priv->atmu_regs + 2;
+ priv->msg_regs = (struct rio_msg_regs *)(priv->regs_win +
+ ((port->phy_type == RIO_PHY_SERIAL) ?
+ RIO_S_MSG_REGS_OFFSET : RIO_P_MSG_REGS_OFFSET));
+
+ /* Set to receive any dist ID for serial RapidIO controller. */
+ if (port->phy_type == RIO_PHY_SERIAL)
+ out_be32((priv->regs_win + RIO_ISR_AACR), RIO_ISR_AACR_AA);