+config I2C2_OMAP_BEAGLE
+ bool "Enable I2C2 for OMAP3 BeagleBoard"
+ depends on ARCH_OMAP && MACH_OMAP3_BEAGLE
+ select OMAP_MUX
+ default n
+ help
+ Say Y here if you want to enable I2C bus 2 at OMAP3 based
+ BeagleBoard.
+ I2C2 at BeagleBoard is connected to expansion connector, i.e. unused
+ if nothing is connected to this connector. As internal OMAP3 pull up
+ resistors are not strong enough, enabled but unused I2C2 bus results
+ in error messages (e.g. I2C timeouts). Enable this only if you have
+ something connected to I2C2 at board's expansion connector and this
+ extension has additional pull up resistors for I2C2 bus.
+