+ This option enables support for the front LED on Cobalt Qube series
+
+config LEDS_COBALT_RAQ
+ bool "LED Support for the Cobalt Raq series"
+ depends on LEDS_CLASS && MIPS_COBALT
+ select LEDS_TRIGGERS
+ help
+ This option enables support for the Cobalt Raq series LEDs.
+
+config LEDS_GPIO
+ tristate "LED Support for GPIO connected LEDs"
+ depends on LEDS_CLASS && GENERIC_GPIO
+ help
+ This option enables support for the LEDs connected to GPIO
+ outputs. To be useful the particular board must have LEDs
+ and they must be connected to the GPIO lines.
+
+config LEDS_CM_X270
+ tristate "LED Support for the CM-X270 LEDs"
+ depends on LEDS_CLASS && MACH_ARMCORE
+ help
+ This option enables support for the CM-X270 LEDs.
+
+config LEDS_CLEVO_MAIL
+ tristate "Mail LED on Clevo notebook (EXPERIMENTAL)"
+ depends on LEDS_CLASS && X86 && SERIO_I8042 && DMI && EXPERIMENTAL
+ help
+ This driver makes the mail LED accessible from userspace
+ programs through the leds subsystem. This LED have three
+ known mode: off, blink at 0.5Hz and blink at 1Hz.
+
+ As this LED cannot change it's brightness it blinks instead.
+ The brightness value 0 means off, 1..127 means blink at 0.5Hz
+ and 128..255 means blink at 1Hz.
+
+ This module can drive the mail LED for the following notebooks:
+
+ Clevo D410J
+ Clevo D410V
+ Clevo D400V/D470V (not tested, but might work)
+ Clevo M540N
+ Clevo M5x0N (not tested, but might work)
+ Positivo Mobile (Clevo M5x0V)
+
+ To compile this driver as a module, choose M here: the
+ module will be called leds-clevo-mail.