-comment "Old SIR device drivers"
-
-config IRPORT_SIR
- tristate "IrPORT (IrDA serial driver)"
- depends on IRDA && BROKEN_ON_SMP
- ---help---
- Say Y here if you want to build support for the IrPORT IrDA device
- driver. To compile it as a module, choose M here: the module will be
- called irport. IrPORT can be used instead of IrTTY and sometimes
- this can be better. One example is if your IrDA port does not
- have echo-canceling, which will work OK with IrPORT since this
- driver is working in half-duplex mode only. You don't need to use
- irattach with IrPORT, but you just insert it the same way as FIR
- drivers (insmod irport io=0x3e8 irq=11). Notice that IrPORT is a
- SIR device driver which means that speed is limited to 115200 bps.
-
- If unsure, say Y.
-
-comment "Old Serial dongle support"
-
-config DONGLE_OLD
- bool "Old Serial dongle support"
- depends on IRPORT_SIR && BROKEN_ON_SMP
- help
- Say Y here if you have an infrared device that connects to your
- computer's serial port. These devices are called dongles. Then say Y
- or M to the driver for your particular dongle below.
-
- Note that the answer to this question won't directly affect the
- kernel: saying N will just cause the configurator to skip all
- the questions about serial dongles.
-
-config ESI_DONGLE_OLD
- tristate "ESI JetEye PC dongle"
- depends on DONGLE_OLD && IRDA
- help
- Say Y here if you want to build support for the Extended Systems
- JetEye PC dongle. To compile it as a module, choose M here. The ESI
- dongle attaches to the normal 9-pin serial port connector, and can
- currently only be used by IrTTY. To activate support for ESI
- dongles you will have to start irattach like this:
- "irattach -d esi".
-
-config ACTISYS_DONGLE_OLD
- tristate "ACTiSYS IR-220L and IR220L+ dongle"
- depends on DONGLE_OLD && IRDA