[PATCH] softmac: export highest_supported_rate function

[linux-2.6-omap-h63xx.git] / drivers / spi / Kconfig

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index b77dbd63e596fea9770cde47928dad197ab51e1d..23334c8bc4c75e5c29fcf2415267d3c00397425c 100644 (file)
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -75,21 +75,45 @@ config SPI_BUTTERFLY
          inexpensive battery powered microcontroller evaluation board.
          This same cable can be used to flash new firmware.
 
          inexpensive battery powered microcontroller evaluation board.
          This same cable can be used to flash new firmware.
 

-config SPI_BUTTERFLY
-       tristate "Parallel port adapter for AVR Butterfly (DEVELOPMENT)"
-       depends on SPI_MASTER && PARPORT && EXPERIMENTAL
+config SPI_MPC83xx
+       tristate "Freescale MPC83xx SPI controller"
+       depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL

        select SPI_BITBANG
        help
        select SPI_BITBANG
        help

-         This uses a custom parallel port cable to connect to an AVR
-         Butterfly <http://www.atmel.com/products/avr/butterfly>, an
-         inexpensive battery powered microcontroller evaluation board.
-         This same cable can be used to flash new firmware.
+         This enables using the Freescale MPC83xx SPI controller in master
+         mode.

 
 

+         Note, this driver uniquely supports the SPI controller on the MPC83xx
+         family of PowerPC processors.  The MPC83xx uses a simple set of shift
+         registers for data (opposed to the CPM based descriptor model).
+
+config SPI_PXA2XX
+       tristate "PXA2xx SSP SPI master"
+       depends on SPI_MASTER && ARCH_PXA && EXPERIMENTAL
+       help
+         This enables using a PXA2xx SSP port as a SPI master controller.
+         The driver can be configured to use any SSP port and additional
+         documentation can be found a Documentation/spi/pxa2xx.
+
+config SPI_S3C24XX_GPIO
+       tristate "Samsung S3C24XX series SPI by GPIO"
+       depends on SPI_MASTER && ARCH_S3C2410 && SPI_BITBANG && EXPERIMENTAL
+       help
+         SPI driver for Samsung S3C24XX series ARM SoCs using
+         GPIO lines to provide the SPI bus. This can be used where
+         the inbuilt hardware cannot provide the transfer mode, or
+         where the board is using non hardware connected pins.

 #
 # Add new SPI master controllers in alphabetical order above this line
 #
 
 
 #
 # Add new SPI master controllers in alphabetical order above this line
 #
 
 

+config SPI_S3C24XX
+       tristate "Samsung S3C24XX series SPI"
+       depends on SPI_MASTER && ARCH_S3C2410 && EXPERIMENTAL
+       help
+         SPI driver for Samsung S3C24XX series ARM SoCs
+

 #
 # There are lots of SPI device types, with sensors and memory
 # being probably the most widely used ones.
 #
 # There are lots of SPI device types, with sensors and memory
 # being probably the most widely used ones.