default: 0
acpi_sleep= [HW,ACPI] Sleep options
- Format: { s3_bios, s3_mode, s3_beep }
+ Format: { s3_bios, s3_mode, s3_beep, old_ordering }
See Documentation/power/video.txt for s3_bios and s3_mode.
s3_beep is for debugging; it makes the PC's speaker beep
as soon as the kernel's real-mode entry point is called.
+ old_ordering causes the ACPI 1.0 ordering of the _PTS
+ control method, wrt putting devices into low power
+ states, to be enforced (the ACPI 2.0 ordering of _PTS is
+ used by default).
acpi_sci= [HW,ACPI] ACPI System Control Interrupt trigger mode
Format: { level | edge | high | low }
hd= [EIDE] (E)IDE hard drive subsystem geometry
Format: <cyl>,<head>,<sect>
- hd?= [HW] (E)IDE subsystem
- hd?lun= See Documentation/ide/ide.txt.
-
highmem=nn[KMG] [KNL,BOOT] forces the highmem zone to have an exact
size of <nn>. This works even on boxes that have no
highmem otherwise. This also works to reduce highmem
See Documentation/ide/ide.txt.
idle= [X86]
- Format: idle=poll or idle=mwait
+ Format: idle=poll or idle=mwait, idle=halt, idle=nomwait
Poll forces a polling idle loop that can slightly improves the performance
of waking up a idle CPU, but will use a lot of power and make the system
run hot. Not recommended.
to not use it because it doesn't save as much power as a normal idle
loop use the MONITOR/MWAIT idle loop anyways. Performance should be the same
as idle=poll.
+ idle=halt. Halt is forced to be used for CPU idle.
+ In such case C2/C3 won't be used again.
+ idle=nomwait. Disable mwait for CPU C-states
ide-pci-generic.all-generic-ide [HW] (E)IDE subsystem
Claim all unknown PCI IDE storage controllers.
or
memmap=0x10000$0x18690000
- memtest= [KNL,X86_64] Enable memtest
+ memtest= [KNL,X86] Enable memtest
Format: <integer>
range: 0,4 : pattern number
default : 0 <disable>
This usage is only documented in each driver source
file if at all.
+ nf_conntrack.acct=
+ [NETFILTER] Enable connection tracking flow accounting
+ 0 to disable accounting
+ 1 to enable accounting
+ Default value depends on CONFIG_NF_CT_ACCT that is
+ going to be removed in 2.6.29.
+
nfsaddrs= [NFS]
See Documentation/filesystems/nfsroot.txt.
Use with caution as certain devices share
address decoders between ROMs and other
resources.
+ norom [X86-32,X86_64] Do not assign address space to
+ expansion ROMs that do not already have
+ BIOS assigned address ranges.
irqmask=0xMMMM [X86-32] Set a bit mask of IRQs allowed to be
assigned automatically to PCI devices. You can
make the kernel exclude IRQs of your ISA cards
Note that genuine overcurrent events won't be
reported either.
+ unknown_nmi_panic
+ [X86-32,X86-64]
+ Set unknown_nmi_panic=1 early on boot.
+
usbcore.autosuspend=
[USB] The autosuspend time delay (in seconds) used
for newly-detected USB devices (default 2). This