name device_type compatible Description
---- ----------- ---------- -----------
gpt@<addr> gpt fsl,mpc5200-gpt General purpose timers
+gpt@<addr> gpt fsl,mpc5200-gpt-gpio General purpose
+ timers in GPIO mode
+gpio@<addr> fsl,mpc5200-gpio MPC5200 simple gpio
+ controller
+gpio@<addr> fsl,mpc5200-gpio-wkup MPC5200 wakeup gpio
+ controller
rtc@<addr> rtc mpc5200-rtc Real time clock
mscan@<addr> mscan mpc5200-mscan CAN bus controller
pci@<addr> pci mpc5200-pci PCI bridge
i2s mode. An 'mpc5200b-psc-i2s' node cannot include 'mpc5200-psc-i2s' in the
compatible field.
+7) GPIO controller nodes
+Each GPIO controller node should have the empty property gpio-controller and
+#gpio-cells set to 2. First cell is the GPIO number which is interpreted
+according to the bit numbers in the GPIO control registers. The second cell
+is for flags which is currently unsused.
+
+8) FEC nodes
+The FEC node can specify one of the following properties to configure
+the MII link:
+"fsl,7-wire-mode" - An empty property that specifies the link uses 7-wire
+ mode instead of MII
+"current-speed" - Specifies that the MII should be configured for a fixed
+ speed. This property should contain two cells. The
+ first cell specifies the speed in Mbps and the second
+ should be '0' for half duplex and '1' for full duplex
+"phy-handle" - Contains a phandle to an Ethernet PHY.
+
IV - Extra Notes
================