scsi = SCSI driver, m = AMD (?) as opposed to w for the DC390W/U/F
(NCR53c8X5, X=2/7) driver. Yes, there was also a driver for the latter,
tmscsiw, which supported DC390W/U/F adapters. It's not maintained any more,
-as the ncr53c8xx is perfectly supporting these adpaters since some time.
+as the ncr53c8xx is perfectly supporting these adapters since some time.
The driver first appeared in April 1996, exclusively supported the DC390
and has been enhanced since then in various steps. In May 1998 support for
replaced by the dev index of your scanner). You may try to reset your SCSI
bus afterwards (echo "RESET" >/proc/scsi/tmscsim/?).
The problem seems to be solved as of 2.0d18, thanks to Andreas Rick.
-* If there is a valid partition table, the driver will use it for determing
+* If there is a valid partition table, the driver will use it for determining
the mapping. If there's none, a reasonable mapping (Symbios-like) will be
assumed. Other operating systems may not like this mapping, though
it's consistent with the BIOS' behaviour. Old DC390 drivers ignored the
all the others for the wonderful OS and software.
Thanks to C.L. Huang and Philip Giang (Tekram) for the initial driver
release and support.
-Thanks to Doug Ledford, Gérard Roudier for support with SCSI coding.
+Thanks to Doug Ledford, Gérard Roudier for support with SCSI coding.
Thanks to a lot of people (espec. Chiaki Ishikawa, Andreas Haumer, Hubert
Tonneau) for intensively testing the driver (and even risking data loss
doing this during early revisions).