--------
procfs: /proc/acpi/ibm/hotkey
-sysfs device attribute: hotkey/*
+sysfs device attribute: hotkey_*
Without this driver, only the Fn-F4 key (sleep button) generates an
ACPI event. With the driver loaded, the hotkey feature enabled and the
sysfs notes:
- The hot keys attributes are in a hotkey/ subdirectory off the
- thinkpad device.
-
- bios_enabled:
+ hotkey_bios_enabled:
Returns the status of the hot keys feature when
thinkpad-acpi was loaded. Upon module unload, the hot
key feature status will be restored to this value.
0: hot keys were disabled
1: hot keys were enabled
- bios_mask:
+ hotkey_bios_mask:
Returns the hot keys mask when thinkpad-acpi was loaded.
Upon module unload, the hot keys mask will be restored
to this value.
- enable:
+ hotkey_enable:
Enables/disables the hot keys feature, and reports
current status of the hot keys feature.
0: disables the hot keys feature / feature disabled
1: enables the hot keys feature / feature enabled
- mask:
+ hotkey_mask:
bit mask to enable ACPI event generation for each hot
key (see above). Returns the current status of the hot
keys mask, and allows one to modify it.
---------
procfs: /proc/acpi/ibm/bluetooth
-sysfs device attribute: bluetooth/enable
+sysfs device attribute: bluetooth_enable
This feature shows the presence and current state of a ThinkPad
Bluetooth device in the internal ThinkPad CDC slot.
Sysfs notes:
If the Bluetooth CDC card is installed, it can be enabled /
- disabled through the "bluetooth/enable" thinkpad-acpi device
+ disabled through the "bluetooth_enable" thinkpad-acpi device
attribute, and its current status can also be queried.
enable:
1: enables Bluetooth / Bluetooth is enabled.
Note: this interface will be probably be superseeded by the
- generic rfkill class.
+ generic rfkill class, so it is NOT to be considered stable yet.
Video output control -- /proc/acpi/ibm/video
--------------------------------------------
-----------------
procfs: /proc/acpi/ibm/wan
-sysfs device attribute: wwan/enable
+sysfs device attribute: wwan_enable
This feature is marked EXPERIMENTAL because the implementation
directly accesses hardware registers and may not work as expected. USE
Sysfs notes:
If the W-WAN card is installed, it can be enabled /
- disabled through the "wwan/enable" thinkpad-acpi device
+ disabled through the "wwan_enable" thinkpad-acpi device
attribute, and its current status can also be queried.
enable:
1: enables WWAN card / WWAN card is enabled.
Note: this interface will be probably be superseeded by the
- generic rfkill class.
+ generic rfkill class, so it is NOT to be considered stable yet.
Multiple Commands, Module Parameters
------------------------------------