#include <mach/board.h>
#include <mach/gpio.h>
+#include <mach/at91sam9_smc.h>
+#include "sam9_smc.h"
#include "generic.h"
{
.name = "Bootstrap",
.offset = 0,
- .size = 4 * 1024 * 1024,
+ .size = 4 * SZ_1M,
},
{
.name = "Partition 1",
- .offset = 4 * 1024 * 1024,
- .size = 60 * 1024 * 1024,
+ .offset = MTDPART_OFS_NXTBLK,
+ .size = 60 * SZ_1M,
},
{
.name = "Partition 2",
- .offset = 64 * 1024 * 1024,
+ .offset = MTDPART_OFS_NXTBLK,
.size = MTDPART_SIZ_FULL,
},
};
#endif
};
+static struct sam9_smc_config __initdata ek_nand_smc_config = {
+ .ncs_read_setup = 0,
+ .nrd_setup = 2,
+ .ncs_write_setup = 0,
+ .nwe_setup = 2,
+
+ .ncs_read_pulse = 4,
+ .nrd_pulse = 4,
+ .ncs_write_pulse = 4,
+ .nwe_pulse = 4,
+
+ .read_cycle = 7,
+ .write_cycle = 7,
+
+ .mode = AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_EXNWMODE_DISABLE,
+ .tdf_cycles = 3,
+};
+
+static void __init ek_add_device_nand(void)
+{
+ /* setup bus-width (8 or 16) */
+ if (ek_nand_data.bus_width_16)
+ ek_nand_smc_config.mode |= AT91_SMC_DBW_16;
+ else
+ ek_nand_smc_config.mode |= AT91_SMC_DBW_8;
+
+ /* configure chip-select 3 (NAND) */
+ sam9_smc_configure(3, &ek_nand_smc_config);
+
+ at91_add_device_nand(&ek_nand_data);
+}
+
/*
* MCI (SD/MMC)
/* SPI */
at91_add_device_spi(ek_spi_devices, ARRAY_SIZE(ek_spi_devices));
/* NAND */
- at91_add_device_nand(&ek_nand_data);
+ ek_add_device_nand();
/* Ethernet */
at91_add_device_eth(&ek_macb_data);
/* MMC */