#include <linux/mfd/tmio.h>
#include <linux/mtd/nand.h>
#include <linux/mtd/partitions.h>
+#include <linux/mtd/physmap.h>
#include <linux/pm.h>
#include <linux/gpio_keys.h>
#include <linux/input.h>
#include <linux/gpio.h>
#include <linux/pda_power.h>
#include <linux/rfkill.h>
+#include <linux/spi/spi.h>
#include <asm/setup.h>
#include <asm/mach-types.h>
#include <mach/mmc.h>
#include <mach/udc.h>
#include <mach/tosa_bt.h>
+#include <mach/pxa2xx_spi.h>
#include <asm/mach/arch.h>
#include <mach/tosa.h>
rc = gpio_request(TOSA_GPIO_TC6393XB_SUSPEND, "tc6393xb #suspend");
if (rc)
goto err_req_suspend;
- rc = gpio_request(TOSA_GPIO_TC6393XB_L3V_ON, "l3v");
+ rc = gpio_request(TOSA_GPIO_TC6393XB_L3V_ON, "tc6393xb l3v");
if (rc)
goto err_req_l3v;
rc = gpio_direction_output(TOSA_GPIO_TC6393XB_L3V_ON, 0);
gpio_free(TOSA_GPIO_CARD_VCC_ON);
}
+#ifdef CONFIG_MFD_TC6393XB
+static struct fb_videomode tosa_tc6393xb_lcd_mode[] = {
+ {
+ .xres = 480,
+ .yres = 640,
+ .pixclock = 0x002cdf00,/* PLL divisor */
+ .left_margin = 0x004c,
+ .right_margin = 0x005b,
+ .upper_margin = 0x0001,
+ .lower_margin = 0x000d,
+ .hsync_len = 0x0002,
+ .vsync_len = 0x0001,
+ .sync = FB_SYNC_HOR_HIGH_ACT | FB_SYNC_VERT_HIGH_ACT,
+ .vmode = FB_VMODE_NONINTERLACED,
+ },{
+ .xres = 240,
+ .yres = 320,
+ .pixclock = 0x00e7f203,/* PLL divisor */
+ .left_margin = 0x0024,
+ .right_margin = 0x002f,
+ .upper_margin = 0x0001,
+ .lower_margin = 0x000d,
+ .hsync_len = 0x0002,
+ .vsync_len = 0x0001,
+ .sync = FB_SYNC_HOR_HIGH_ACT | FB_SYNC_VERT_HIGH_ACT,
+ .vmode = FB_VMODE_NONINTERLACED,
+ }
+};
+
+static struct tmio_fb_data tosa_tc6393xb_fb_config = {
+ .lcd_set_power = tc6393xb_lcd_set_power,
+ .lcd_mode = tc6393xb_lcd_mode,
+ .num_modes = ARRAY_SIZE(tosa_tc6393xb_lcd_mode),
+ .modes = &tosa_tc6393xb_lcd_mode[0],
+ .height = 82,
+ .width = 60,
+};
+#endif
+
static struct tc6393xb_platform_data tosa_tc6393xb_data = {
.scr_pll2cr = 0x0cc1,
.scr_gper = 0x3300,
.resume = tosa_tc6393xb_resume,
.nand_data = &tosa_tc6393xb_nand_config,
+#ifdef CONFIG_MFD_TC6393XB
+ .fb_data = &tosa_tc6393xb_fb_config,
+#endif
.resume_restore = 1,
};
.dev.platform_data = &tosa_bt_data,
};
+static struct pxa2xx_spi_master pxa_ssp_master_info = {
+ .num_chipselect = 1,
+};
+
+static struct spi_board_info spi_board_info[] __initdata = {
+ {
+ .modalias = "tosa-lcd",
+ // .platform_data
+ .max_speed_hz = 28750,
+ .bus_num = 2,
+ .chip_select = 0,
+ .mode = SPI_MODE_0,
+ },
+};
+
+static struct mtd_partition sharpsl_rom_parts[] = {
+ {
+ .name ="Boot PROM Filesystem",
+ .offset = 0x00160000,
+ .size = MTDPART_SIZ_FULL,
+ },
+};
+
+static struct physmap_flash_data sharpsl_rom_data = {
+ .width = 2,
+ .nr_parts = ARRAY_SIZE(sharpsl_rom_parts),
+ .parts = sharpsl_rom_parts,
+};
+
+static struct resource sharpsl_rom_resources[] = {
+ {
+ .start = 0x00000000,
+ .end = 0x007fffff,
+ .flags = IORESOURCE_MEM,
+ },
+};
+
+static struct platform_device sharpsl_rom_device = {
+ .name = "physmap-flash",
+ .id = -1,
+ .resource = sharpsl_rom_resources,
+ .num_resources = ARRAY_SIZE(sharpsl_rom_resources),
+ .dev.platform_data = &sharpsl_rom_data,
+};
static struct platform_device *devices[] __initdata = {
&tosascoop_device,
&tosa_gpio_keys_device,
&tosaled_device,
&tosa_bt_device,
+ &sharpsl_rom_device,
};
static void tosa_poweroff(void)
pxa_set_i2c_info(NULL);
platform_scoop_config = &tosa_pcmcia_config;
+ pxa2xx_set_spi_info(2, &pxa_ssp_master_info);
+ spi_register_board_info(spi_board_info, ARRAY_SIZE(spi_board_info));
+
clk_add_alias("CLK_CK3P6MI", &tc6393xb_device.dev, "GPIO11_CLK", NULL);
platform_add_devices(devices, ARRAY_SIZE(devices));