#include <asm/page.h>
#include <asm/msr.h>
#include <asm/cache.h>
+#include <asm/processor-flags.h>
#ifdef CONFIG_PARAVIRT
#include <asm/asm-offsets.h>
/* Fixup phys_base */
addq %rbp, phys_base(%rip)
-#ifdef CONFIG_SMP
+#ifdef CONFIG_X86_TRAMPOLINE
addq %rbp, trampoline_level4_pgt + 0(%rip)
addq %rbp, trampoline_level4_pgt + (511*8)(%rip)
#endif
-#ifdef CONFIG_ACPI_SLEEP
- addq %rbp, wakeup_level4_pgt + 0(%rip)
- addq %rbp, wakeup_level4_pgt + (511*8)(%rip)
-#endif
/* Due to ENTRY(), sometimes the empty space gets filled with
* zeros. Better take a jmp than relying on empty space being
*/
/* Enable PAE mode and PGE */
- xorq %rax, %rax
- btsq $5, %rax
- btsq $7, %rax
+ movl $(X86_CR4_PAE | X86_CR4_PGE), %eax
movq %rax, %cr4
/* Setup early boot stage 4 level pagetables. */
1: wrmsr /* Make changes effective */
/* Setup cr0 */
-#define CR0_PM 1 /* protected mode */
-#define CR0_MP (1<<1)
-#define CR0_ET (1<<4)
-#define CR0_NE (1<<5)
-#define CR0_WP (1<<16)
-#define CR0_AM (1<<18)
-#define CR0_PAGING (1<<31)
- movl $CR0_PM|CR0_MP|CR0_ET|CR0_NE|CR0_WP|CR0_AM|CR0_PAGING,%eax
+#define CR0_STATE (X86_CR0_PE | X86_CR0_MP | X86_CR0_ET | \
+ X86_CR0_NE | X86_CR0_WP | X86_CR0_AM | \
+ X86_CR0_PG)
+ movl $CR0_STATE, %eax
/* Make changes effective */
movq %rax, %cr0
bad_address:
jmp bad_address
+ .section ".init.text","ax"
#ifdef CONFIG_EARLY_PRINTK
-.macro early_idt_tramp first, last
- .ifgt \last-\first
- early_idt_tramp \first, \last-1
- .endif
- movl $\last,%esi
- jmp early_idt_handler
-.endm
-
.globl early_idt_handlers
early_idt_handlers:
- early_idt_tramp 0, 63
- early_idt_tramp 64, 127
- early_idt_tramp 128, 191
- early_idt_tramp 192, 255
+ i = 0
+ .rept NUM_EXCEPTION_VECTORS
+ movl $i, %esi
+ jmp early_idt_handler
+ i = i + 1
+ .endr
#endif
ENTRY(early_idt_handler)
early_idt_ripmsg:
.asciz "RIP %s\n"
#endif /* CONFIG_EARLY_PRINTK */
+ .previous
.balign PAGE_SIZE
ENTRY(name)
/* Automate the creation of 1 to 1 mapping pmd entries */
-#define PMDS(START, PERM, COUNT) \
- i = 0 ; \
- .rept (COUNT) ; \
- .quad (START) + (i << 21) + (PERM) ; \
- i = i + 1 ; \
+#define PMDS(START, PERM, COUNT) \
+ i = 0 ; \
+ .rept (COUNT) ; \
+ .quad (START) + (i << PMD_SHIFT) + (PERM) ; \
+ i = i + 1 ; \
.endr
/*
NEXT_PAGE(level2_kernel_pgt)
/*
- * 128 MB kernel mapping. We spend a full page on this pagetable
+ * 512 MB kernel mapping. We spend a full page on this pagetable
* anyway.
*
* The kernel code+data+bss must not be bigger than that.
*
- * (NOTE: at +128MB starts the module area, see MODULES_VADDR.
+ * (NOTE: at +512MB starts the module area, see MODULES_VADDR.
* If you want to increase this then increase MODULES_VADDR
* too.)
*/