it821x_program(ap, adev, itdev->pio[adev->devno]);
itdev->last_device = device;
}
- ata_std_dev_select(ap, device);
+ ata_sff_dev_select(ap, device);
}
/**
- * it821x_smart_qc_issue_prot - wrap qc issue prot
+ * it821x_smart_qc_issue - wrap qc issue prot
* @qc: command
*
* Wrap the command issue sequence for the IT821x. We need to
* usual happenings kick off
*/
-static unsigned int it821x_smart_qc_issue_prot(struct ata_queued_cmd *qc)
+static unsigned int it821x_smart_qc_issue(struct ata_queued_cmd *qc)
{
switch(qc->tf.command)
{
case ATA_CMD_ID_ATA:
/* Arguably should just no-op this one */
case ATA_CMD_SET_FEATURES:
- return ata_qc_issue_prot(qc);
+ return ata_sff_qc_issue(qc);
}
printk(KERN_DEBUG "it821x: can't process command 0x%02X\n", qc->tf.command);
- return AC_ERR_INVALID;
+ return AC_ERR_DEV;
}
/**
- * it821x_passthru_qc_issue_prot - wrap qc issue prot
+ * it821x_passthru_qc_issue - wrap qc issue prot
* @qc: command
*
* Wrap the command issue sequence for the IT821x. We need to
* usual happenings kick off
*/
-static unsigned int it821x_passthru_qc_issue_prot(struct ata_queued_cmd *qc)
+static unsigned int it821x_passthru_qc_issue(struct ata_queued_cmd *qc)
{
it821x_passthru_dev_select(qc->ap, qc->dev->devno);
- return ata_qc_issue_prot(qc);
+ return ata_sff_qc_issue(qc);
}
/**
printk("(%dK stripe)", adev->id[146]);
printk(".\n");
}
+ /* This is a controller firmware triggered funny, don't
+ report the drive faulty! */
+ adev->horkage &= ~ATA_HORKAGE_DIAGNOSTIC;
+}
+
+/**
+ * it821x_ident_hack - Hack identify data up
+ * @ap: Port
+ *
+ * Walk the devices on this firmware driven port and slightly
+ * mash the identify data to stop us and common tools trying to
+ * use features not firmware supported. The firmware itself does
+ * some masking (eg SMART) but not enough.
+ *
+ * This is a bit of an abuse of the cable method, but it is the
+ * only method called at the right time. We could modify the libata
+ * core specifically for ident hacking but while we have one offender
+ * it seems better to keep the fallout localised.
+ */
+
+static int it821x_ident_hack(struct ata_port *ap)
+{
+ struct ata_device *adev;
+ ata_link_for_each_dev(adev, &ap->link) {
+ if (ata_dev_enabled(adev)) {
+ adev->id[84] &= ~(1 << 6); /* No FUA */
+ adev->id[85] &= ~(1 << 10); /* No HPA */
+ adev->id[76] = 0; /* No NCQ/AN etc */
+ }
+ }
+ return ata_cable_unknown(ap);
}
struct it821x_dev *itdev = ap->private_data;
/* Only use dma for transfers to/from the media. */
- if (qc->nbytes < 2048)
+ if (ata_qc_raw_nbytes(qc) < 2048)
return -EOPNOTSUPP;
/* No ATAPI DMA in smart mode */
}
static struct scsi_host_template it821x_sht = {
- .module = THIS_MODULE,
- .name = DRV_NAME,
- .ioctl = ata_scsi_ioctl,
- .queuecommand = ata_scsi_queuecmd,
- .can_queue = ATA_DEF_QUEUE,
- .this_id = ATA_SHT_THIS_ID,
- .sg_tablesize = LIBATA_MAX_PRD,
- .cmd_per_lun = ATA_SHT_CMD_PER_LUN,
- .emulated = ATA_SHT_EMULATED,
- .use_clustering = ATA_SHT_USE_CLUSTERING,
- .proc_name = DRV_NAME,
- .dma_boundary = ATA_DMA_BOUNDARY,
- .slave_configure = ata_scsi_slave_config,
- .slave_destroy = ata_scsi_slave_destroy,
- .bios_param = ata_std_bios_param,
+ ATA_BMDMA_SHT(DRV_NAME),
};
static struct ata_port_operations it821x_smart_port_ops = {
- .set_mode = it821x_smart_set_mode,
- .tf_load = ata_tf_load,
- .tf_read = ata_tf_read,
- .mode_filter = ata_pci_default_filter,
+ .inherits = &ata_bmdma_port_ops,
- .check_status = ata_check_status,
.check_atapi_dma= it821x_check_atapi_dma,
- .exec_command = ata_exec_command,
- .dev_select = ata_std_dev_select,
- .dev_config = it821x_dev_config,
-
- .freeze = ata_bmdma_freeze,
- .thaw = ata_bmdma_thaw,
- .error_handler = ata_bmdma_error_handler,
- .post_internal_cmd = ata_bmdma_post_internal_cmd,
- .cable_detect = ata_cable_unknown,
-
- .bmdma_setup = ata_bmdma_setup,
- .bmdma_start = ata_bmdma_start,
- .bmdma_stop = ata_bmdma_stop,
- .bmdma_status = ata_bmdma_status,
-
- .qc_prep = ata_qc_prep,
- .qc_issue = it821x_smart_qc_issue_prot,
+ .qc_issue = it821x_smart_qc_issue,
- .data_xfer = ata_data_xfer,
-
- .irq_handler = ata_interrupt,
- .irq_clear = ata_bmdma_irq_clear,
- .irq_on = ata_irq_on,
+ .cable_detect = it821x_ident_hack,
+ .set_mode = it821x_smart_set_mode,
+ .dev_config = it821x_dev_config,
.port_start = it821x_port_start,
};
static struct ata_port_operations it821x_passthru_port_ops = {
- .set_piomode = it821x_passthru_set_piomode,
- .set_dmamode = it821x_passthru_set_dmamode,
- .mode_filter = ata_pci_default_filter,
+ .inherits = &ata_bmdma_port_ops,
- .tf_load = ata_tf_load,
- .tf_read = ata_tf_read,
- .check_status = ata_check_status,
- .exec_command = ata_exec_command,
.check_atapi_dma= it821x_check_atapi_dma,
- .dev_select = it821x_passthru_dev_select,
-
- .freeze = ata_bmdma_freeze,
- .thaw = ata_bmdma_thaw,
- .error_handler = ata_bmdma_error_handler,
- .post_internal_cmd = ata_bmdma_post_internal_cmd,
- .cable_detect = ata_cable_unknown,
-
- .bmdma_setup = ata_bmdma_setup,
+ .sff_dev_select = it821x_passthru_dev_select,
.bmdma_start = it821x_passthru_bmdma_start,
.bmdma_stop = it821x_passthru_bmdma_stop,
- .bmdma_status = ata_bmdma_status,
+ .qc_issue = it821x_passthru_qc_issue,
- .qc_prep = ata_qc_prep,
- .qc_issue = it821x_passthru_qc_issue_prot,
-
- .data_xfer = ata_data_xfer,
-
- .irq_clear = ata_bmdma_irq_clear,
- .irq_handler = ata_interrupt,
- .irq_on = ata_irq_on,
+ .cable_detect = ata_cable_unknown,
+ .set_piomode = it821x_passthru_set_piomode,
+ .set_dmamode = it821x_passthru_set_dmamode,
.port_start = it821x_port_start,
};
u8 conf;
static const struct ata_port_info info_smart = {
- .sht = &it821x_sht,
.flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
.port_ops = &it821x_smart_port_ops
};
static const struct ata_port_info info_passthru = {
- .sht = &it821x_sht,
.flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
const struct ata_port_info *ppi[] = { NULL, NULL };
static char *mode[2] = { "pass through", "smart" };
+ int rc;
+
+ rc = pcim_enable_device(pdev);
+ if (rc)
+ return rc;
/* Force the card into bypass mode if so requested */
if (it8212_noraid) {
else
ppi[0] = &info_smart;
- return ata_pci_init_one(pdev, ppi);
+ return ata_pci_sff_init_one(pdev, ppi, &it821x_sht, NULL);
}
#ifdef CONFIG_PM
static int it821x_reinit_one(struct pci_dev *pdev)
{
+ struct ata_host *host = dev_get_drvdata(&pdev->dev);
+ int rc;
+
+ rc = ata_pci_device_do_resume(pdev);
+ if (rc)
+ return rc;
/* Resume - turn raid back off if need be */
if (it8212_noraid)
it821x_disable_raid(pdev);
- return ata_pci_device_resume(pdev);
+ ata_host_resume(host);
+ return rc;
}
#endif
projects / linux-2.6-omap-h63xx.git / blobdiff