[SCSI] add supported_mode and active_mode attributes to the host

[linux-2.6-omap-h63xx.git] / drivers / char / specialix.c

diff --git a/drivers/char/specialix.c b/drivers/char/specialix.c
index baf7234b6e662fd8277368ecdf854ca2246de4d6..455855631aeff70f441e26be40f3a745a4cb5609 100644 (file)
--- a/drivers/char/specialix.c
+++ b/drivers/char/specialix.c
@@ -345,18 +345,6 @@ static inline void sx_release_io_range(struct specialix_board * bp)
 }
 
 
-/* Must be called with enabled interrupts */
-/* Ugly. Very ugly. Don't use this for anything else than initialization
-   code */
-static inline void sx_long_delay(unsigned long delay)
-{
-       unsigned long i;
-
-       for (i = jiffies + delay; time_after(i, jiffies); ) ;
-}
-
-
-
 /* Set the IRQ using the RTS lines that run to the PAL on the board.... */
 static int sx_set_irq ( struct specialix_board *bp)
 {
@@ -397,7 +385,7 @@ static int sx_init_CD186x(struct specialix_board  * bp)
        spin_lock_irqsave(&bp->lock, flags);
        sx_out_off(bp, CD186x_CCR, CCR_HARDRESET);      /* Reset CD186x chip          */
        spin_unlock_irqrestore(&bp->lock, flags);
-       sx_long_delay(HZ/20);                      /* Delay 0.05 sec            */
+       msleep(50);                                     /* Delay 0.05 sec            */
        spin_lock_irqsave(&bp->lock, flags);
        sx_out_off(bp, CD186x_GIVR, SX_ID);             /* Set ID for this chip      */
        sx_out_off(bp, CD186x_GICR, 0);                 /* Clear all bits            */
@@ -533,7 +521,7 @@ static int sx_probe(struct specialix_board *bp)
                sx_wait_CCR(bp);
                sx_out(bp, CD186x_CCR, CCR_TXEN);        /* Enable transmitter     */
                sx_out(bp, CD186x_IER, IER_TXRDY);       /* Enable tx empty intr   */
-               sx_long_delay(HZ/20);
+               msleep(50);
                irqs = probe_irq_off(irqs);
 
                dprintk (SX_DEBUG_INIT, "SRSR = %02x, ", sx_in(bp, CD186x_SRSR));