[SCSI] aacraid: informational sysfs value corrections

[linux-2.6-omap-h63xx.git] / drivers / char / specialix.c

diff --git a/drivers/char/specialix.c b/drivers/char/specialix.c
index baf7234b6e662fd8277368ecdf854ca2246de4d6..c0e08c7bca2f4ef713c966eeed532164d33282e6 100644 (file)
--- a/drivers/char/specialix.c
+++ b/drivers/char/specialix.c
@@ -178,9 +178,6 @@ static int sx_poll = HZ;
         ASYNC_SPD_HI       | ASYNC_SPEED_VHI    | ASYNC_SESSION_LOCKOUT | \
         ASYNC_PGRP_LOCKOUT | ASYNC_CALLOUT_NOHUP)
 
-#undef RS_EVENT_WRITE_WAKEUP
-#define RS_EVENT_WRITE_WAKEUP  0
-
 static struct tty_driver *specialix_driver;
 
 static struct specialix_board sx_board[SX_NBOARD] =  {
@@ -345,18 +342,6 @@ static inline void sx_release_io_range(struct specialix_board * bp)
 }
 
 
-/* Must be called with enabled interrupts */
-/* Ugly. Very ugly. Don't use this for anything else than initialization
-   code */
-static inline void sx_long_delay(unsigned long delay)
-{
-       unsigned long i;
-
-       for (i = jiffies + delay; time_after(i, jiffies); ) ;
-}
-
-
-
 /* Set the IRQ using the RTS lines that run to the PAL on the board.... */
 static int sx_set_irq ( struct specialix_board *bp)
 {
@@ -397,7 +382,7 @@ static int sx_init_CD186x(struct specialix_board  * bp)
        spin_lock_irqsave(&bp->lock, flags);
        sx_out_off(bp, CD186x_CCR, CCR_HARDRESET);      /* Reset CD186x chip          */
        spin_unlock_irqrestore(&bp->lock, flags);
-       sx_long_delay(HZ/20);                      /* Delay 0.05 sec            */
+       msleep(50);                                     /* Delay 0.05 sec            */
        spin_lock_irqsave(&bp->lock, flags);
        sx_out_off(bp, CD186x_GIVR, SX_ID);             /* Set ID for this chip      */
        sx_out_off(bp, CD186x_GICR, 0);                 /* Clear all bits            */
@@ -533,7 +518,7 @@ static int sx_probe(struct specialix_board *bp)
                sx_wait_CCR(bp);
                sx_out(bp, CD186x_CCR, CCR_TXEN);        /* Enable transmitter     */
                sx_out(bp, CD186x_IER, IER_TXRDY);       /* Enable tx empty intr   */
-               sx_long_delay(HZ/20);
+               msleep(50);
                irqs = probe_irq_off(irqs);
 
                dprintk (SX_DEBUG_INIT, "SRSR = %02x, ", sx_in(bp, CD186x_SRSR));
@@ -614,17 +599,6 @@ static int sx_probe(struct specialix_board *bp)
  *  Interrupt processing routines.
  * */
 
-static inline void sx_mark_event(struct specialix_port * port, int event)
-{
-       func_enter();
-
-       set_bit(event, &port->event);
-       schedule_work(&port->tqueue);
-
-       func_exit();
-}
-
-
 static inline struct specialix_port * sx_get_port(struct specialix_board * bp,
                                               unsigned char const * what)
 {
@@ -821,7 +795,7 @@ static inline void sx_transmit(struct specialix_board * bp)
                sx_out(bp, CD186x_IER, port->IER);
        }
        if (port->xmit_cnt <= port->wakeup_chars)
-               sx_mark_event(port, RS_EVENT_WRITE_WAKEUP);
+               tty_wakeup(tty);
 
        func_exit();
 }
@@ -851,7 +825,7 @@ static inline void sx_check_modem(struct specialix_board * bp)
                        wake_up_interruptible(&port->open_wait);
                } else {
                        dprintk (SX_DEBUG_SIGNALS, "Sending HUP.\n");
-                       schedule_work(&port->tqueue_hangup);
+                       tty_hangup(tty);
                }
        }
 
@@ -861,7 +835,7 @@ static inline void sx_check_modem(struct specialix_board * bp)
                        tty->hw_stopped = 0;
                        port->IER |= IER_TXRDY;
                        if (port->xmit_cnt <= port->wakeup_chars)
-                               sx_mark_event(port, RS_EVENT_WRITE_WAKEUP);
+                               tty_wakeup(tty);
                } else {
                        tty->hw_stopped = 1;
                        port->IER &= ~IER_TXRDY;
@@ -873,7 +847,7 @@ static inline void sx_check_modem(struct specialix_board * bp)
                        tty->hw_stopped = 0;
                        port->IER |= IER_TXRDY;
                        if (port->xmit_cnt <= port->wakeup_chars)
-                               sx_mark_event(port, RS_EVENT_WRITE_WAKEUP);
+                               tty_wakeup(tty);
                } else {
                        tty->hw_stopped = 1;
                        port->IER &= ~IER_TXRDY;
@@ -1630,7 +1604,6 @@ static void sx_close(struct tty_struct * tty, struct file * filp)
        tty_ldisc_flush(tty);
        spin_lock_irqsave(&port->lock, flags);
        tty->closing = 0;
-       port->event = 0;
        port->tty = NULL;
        spin_unlock_irqrestore(&port->lock, flags);
        if (port->blocked_open) {
@@ -2247,32 +2220,6 @@ static void sx_start(struct tty_struct * tty)
        func_exit();
 }
 
-
-/*
- * This routine is called from the work-queue when the interrupt
- * routine has signalled that a hangup has occurred.  The path of
- * hangup processing is:
- *
- *     serial interrupt routine -> (workqueue) ->
- *     do_sx_hangup() -> tty->hangup() -> sx_hangup()
- *
- */
-static void do_sx_hangup(struct work_struct *work)
-{
-       struct specialix_port   *port =
-               container_of(work, struct specialix_port, tqueue_hangup);
-       struct tty_struct       *tty;
-
-       func_enter();
-
-       tty = port->tty;
-       if (tty)
-               tty_hangup(tty);        /* FIXME: module removal race here */
-
-       func_exit();
-}
-
-
 static void sx_hangup(struct tty_struct * tty)
 {
        struct specialix_port *port = (struct specialix_port *)tty->driver_data;
@@ -2290,7 +2237,6 @@ static void sx_hangup(struct tty_struct * tty)
 
        sx_shutdown_port(bp, port);
        spin_lock_irqsave(&port->lock, flags);
-       port->event = 0;
        bp->count -= port->count;
        if (bp->count < 0) {
                printk(KERN_ERR "sx%d: sx_hangup: bad board count: %d port: %d\n",
@@ -2332,26 +2278,6 @@ static void sx_set_termios(struct tty_struct * tty, struct ktermios * old_termio
        }
 }
 
-
-static void do_softint(struct work_struct *work)
-{
-       struct specialix_port   *port =
-               container_of(work, struct specialix_port, tqueue);
-       struct tty_struct       *tty;
-
-       func_enter();
-
-       if(!(tty = port->tty)) {
-               func_exit();
-               return;
-       }
-
-       if (test_and_clear_bit(RS_EVENT_WRITE_WAKEUP, &port->event))
-               tty_wakeup(tty);
-
-       func_exit();
-}
-
 static const struct tty_operations sx_ops = {
        .open  = sx_open,
        .close = sx_close,
@@ -2409,8 +2335,6 @@ static int sx_init_drivers(void)
        memset(sx_port, 0, sizeof(sx_port));
        for (i = 0; i < SX_NPORT * SX_NBOARD; i++) {
                sx_port[i].magic = SPECIALIX_MAGIC;
-               INIT_WORK(&sx_port[i].tqueue, do_softint);
-               INIT_WORK(&sx_port[i].tqueue_hangup, do_sx_hangup);
                sx_port[i].close_delay = 50 * HZ/100;
                sx_port[i].closing_wait = 3000 * HZ/100;
                init_waitqueue_head(&sx_port[i].open_wait);