[PATCH] autofs4: expire mounts that hold no (extra) references only

[linux-2.6-omap-h63xx.git] / drivers / ide / Kconfig

diff --git a/drivers/ide/Kconfig b/drivers/ide/Kconfig
index 1c81174595b3ce12db4ee9d8194d29b61d92c67b..d633081fa4c58123bc8769e7439af651039cb415 100644 (file)
--- a/drivers/ide/Kconfig
+++ b/drivers/ide/Kconfig
@@ -52,9 +52,9 @@ config IDE
 
 if IDE
 
-config IDE_MAX_HWIFS 
+config IDE_MAX_HWIFS
        int "Max IDE interfaces"
-       depends on ALPHA || SUPERH
+       depends on ALPHA || SUPERH || IA64
        default 4
        help
          This is the maximum number of IDE hardware interfaces that will
@@ -162,8 +162,8 @@ config BLK_DEV_IDECS
        tristate "PCMCIA IDE support"
        depends on PCMCIA
        help
-         Support for outboard IDE disks, tape drives, and CD-ROM drives
-         connected through a  PCMCIA card.
+         Support for Compact Flash cards, outboard IDE disks, tape drives,
+         and CD-ROM drives connected through a PCMCIA card.
 
 config BLK_DEV_IDECD
        tristate "Include IDE/ATAPI CDROM support"
@@ -267,7 +267,7 @@ config IDE_TASK_IOCTL
        help
          This is a direct raw access to the media.  It is a complex but
          elegant solution to test and validate the domain of the hardware and
-         perform below the driver data recover if needed.  This is the most
+         perform below the driver data recovery if needed.  This is the most
          basic form of media-forensics.
 
          If you are unsure, say N here.
@@ -525,7 +525,7 @@ config BLK_DEV_CS5520
        tristate "Cyrix CS5510/20 MediaGX chipset support (VERY EXPERIMENTAL)"
        depends on EXPERIMENTAL
        help
-         Include support for PIO tuning an virtual DMA on the Cyrix MediaGX 
+         Include support for PIO tuning and virtual DMA on the Cyrix MediaGX
          5510/5520 chipset. This will automatically be detected and
          configured if found.
 
@@ -662,7 +662,7 @@ config PDC202XX_BURST
 
          It was originally designed for the PDC20246/Ultra33, whose BIOS will
          only setup UDMA on the first two PDC20246 cards.  It has also been
-         used succesfully on a PDC20265/Ultra100, allowing use of UDMA modes
+         used successfully on a PDC20265/Ultra100, allowing use of UDMA modes
          when the PDC20265 BIOS has been disabled (for faster boot up).
 
          Please read the comments at the top of
@@ -673,13 +673,6 @@ config PDC202XX_BURST
 config BLK_DEV_PDC202XX_NEW
        tristate "PROMISE PDC202{68|69|70|71|75|76|77} support"
 
-# FIXME - probably wants to be one for old and for new
-config PDC202XX_FORCE
-       bool "Enable controller even if disabled by BIOS"
-       depends on BLK_DEV_PDC202XX_NEW
-       help
-         Enable the PDC202xx controller even if it has been disabled in the BIOS setup.
-
 config BLK_DEV_SVWKS
        tristate "ServerWorks OSB4/CSB5/CSB6 chipsets support"
        help
@@ -722,7 +715,7 @@ config BLK_DEV_SIS5513
 config BLK_DEV_SLC90E66
        tristate "SLC90E66 chipset support"
        help
-         This driver ensures (U)DMA support for Victroy66 SouthBridges for
+         This driver ensures (U)DMA support for Victory66 SouthBridges for
          SMsC with Intel NorthBridges.  This is an Ultra66 based chipset.
          The nice thing about it is that you can mix Ultra/DMA/PIO devices
          and it will handle timing cycles.  Since this is an improved
@@ -1060,7 +1053,7 @@ config IDEDMA_IVB
          in that mode with an 80c ribbon.
 
          If you are experiencing compatibility or performance problems, you
-         MAY try to answering Y here. However, it does not necessarily solve
+         MAY try to answer Y here. However, it does not necessarily solve
          any of your problems, it could even cause more of them.
 
          It is normally safe to answer Y; however, the default is N.